Abstract:Supported V2O5–WO3/TiO2 materials are employed as selective catalytic reduction (SCR) catalysts for NOx emission control from power plants. Fresh SCR catalysts usually receive exposure to harsh treatments in the industry to accelerate catalyst activation (calcination in air at 650 °C) and catalyst aging (hydrothermal aging at 650 °C) in a way that represents various points in the catalyst/product lifetime. The present study investigates the catalyst structural and chemical changes occurring during such harsh treatments. Three series of supported V2O5–WO3/TiO2 catalysts were prepared by incipient-wetness impregnation of aqueous ammonium metavanadate and metatungstate precursors. The catalysts were subsequently dried and calcined at 550 °C in O2, 650 °C in O2, and hydrothermal conditions (10% O2, 8% H2O, 7% CO2, and 75% N2) at 650 °C. The resulting catalysts were physically characterized by numerous techniques (in situ Raman; in situ IR; in situ high-field–high-spinning solid-state 51V MAS NMR; in situ electron paramagnetic resonance; X-ray diffraction; Brunauer, Emmett, and Teller surface area; and inductively coupled plasma) and chemically probed with adsorbed ammonia, SCR–TPSR, and the SCR reaction. The surface WOx sites on the TiO2 support behave as a textural promoter that stabilizes the TiO2 (anatase) phase from sintering and transforming to the undesirable crystalline TiO2 (rutile) phase that can lead to formation of a Ti1–xVxO2 (rutile) solid solution with reduced V4+ cations (∼7–15%). The surface VOx sites are mostly oligomerized as surface V5+Ox sites (∼50–85% oligomers) and the extent of oligomerization tends to increase with surface WOx coverage and calcination temperature. A major difference between the calcined and hydrothermally treated catalysts was the low concentration of surface NH3* species on Lewis acid sites for the hydrothermally treated catalysts, yet the SCR activity was almost comparable for both catalysts. This finding suggests that surface NH4+*, primarily associated with the surface VOx sites, are able to efficiently perform the SCR reaction. Given that multiple catalyst parameters were simultaneously varying during these treatments, it was difficult to correlate the SCR activity with any single catalyst parameter. A correlation, however, was found between the SCR TOF/activity and the sum of the surface NH3* and NH4+* species, which is dominated by the surface NH4+* species.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c02130.ICP of vanadium content of catalysts; crystallite sizes for supported VWTi catalysts treated at 650 °C; EPR determination of V4+; solid-state 51V MAS NMR spectra of dehydrated supported V2O5–WO3/TiO2 catalysts calcined at 650 °C; EPR spectra of non-vanadium species; in situ TP-IR spectra of surface ammonia species during SCR; correlation plots between steady-state SCR TOF values and structural properties of VWTi catalysts; and radar plots of catalytic activity and catalyst properties (PDF)This article has not yet been cited by other publications.

Hydrothermal Aging Mechanism and Modeling for SCR Catalysts

The Effects of Tungsten and Hydrothermal Aging in Promoting NH3-SCR Activity on V2O5/WO3-TiO2 Catalysts

Hydrothermal Aging Treatment Activates V2O5/TiO2 Catalysts for NOx Abatement

New Findings in Hydrothermal Deactivation Research on the Vanadia-Selective Catalytic Reduction Catalyst

Experimental and numerical study of Cu-SSZ-13 SCR system for NOx reduction and hydrothermal aging under diesel exhaust conditions

Structure–Activity Relationships of Hydrothermally Aged Titania-Supported Vanadium–Tungsten Oxide Catalysts for SCR of NO x Emissions with NH 3

Simulation on Catalytic Performance of Fresh and Aged SCR Catalysts for Diesel Engines

Influence of aging on in situ hydrothermally synthesized Cu-SSZ-13 catalyst for NH3-SCR reaction

Experimental study on the performance and diagnosis of hydrothermally aged selective catalytic reduction over a copper-based catalyst

Aging of Commercial Diesel Oxidation Catalysts: A Preliminary Structure/Reactivity Study

Investigation of the hydrothermal aging of an Mn-based mullite SmMn2O5 catalyst of NO oxidation

Impact of Hydrothermal Aging on SO2 Poisoning over Cu-SSZ-13 Diesel Exhaust SCR Catalysts

Hydrothermal ageing control of diesel engine urea selective catalytic reduction (SCR) based on adaptive time-step extended Kalman filter (ATS-EKF) and combination of open-loop feedforward and closed-loop feedback

Effects of hydrothermal aging at high and low temperatures on the selective catalytic reduction of NO x with NH 3 over Cu/SAPO-34

Effect of the hydrothermal aging temperature and Cu/Al ratio on the hydrothermal stability of CuSSZ-13 catalysts for NH3-SCR

Degenerating Effect of Transformation and Loss of Active Sites on NH3-SCR Activity During the Hydrothermal Aging Process for Cu-SSZ-13 Molecular Sieve Catalyst

Probing Active-Site Relocation in Cu/SSZ-13 SCR Catalysts during Hydrothermal Aging by In Situ EPR Spectroscopy, Kinetics Studies, and DFT Calculations

Influence of hydrothermal aging temperatures on Fe-Beta zeolite commercial NH3-SCR catalyst

Effects of Aging Treatment on the Hydrotreating Performance of the Unsupported Catalyst

Influence of aging on in situ hydrothermally synthesized Cu-SSZ-13 catalyst for NH<sub>3</sub>-SCR reaction

Understanding the Catalytic Deactivation upon Hydrothermal Aging at 850 °C of WO3/Fe-Cu-ZSM-5 Catalyst for Selective Catalytic Reduction of NO by NH3