Abstract:Chinese FY-4M is a new-generation geosynchronous satellite, which will be launched in the near future. It is equipped with multichannel millimeter wave radiometers, which operate in the range of 50-430 GHz. This satellite will increase revisit time and significantly improve the monitoring and weather variation forecasting capabilities. Calibration is an important issue for the quantitative analysis and application of brightness temperature observations. Calibration is first conducted in a thermal/vacuum chamber prior to the launch. A hot target onboard the satellite is used to provide relative irradiance for onboard calibration, and the cold cosmos is used as a cold target. However, complicated space conditions may result in many uncertainties and instabilities during calibration. A new method is required to evaluate the performance of the instruments during long-term operation. Because of the non-existence of atmospheric and other environmental interferences, the lunar surface maintains its physical and chemical stability. Thus, it is an ideal source for thermal calibration. The earliest ground-based observation of thermal microwave emission of the Moon dates back to the early 1940s. At that time, the temperature profile and dielectric constant of the lunar surface had not been studied in detail. Thus, interpreting the observed microwave brightness temperature was difficult. In recent years, many studies of the lunar surface have been performed owing to the advances in satellite-borne remote sensing programs. The Diviner Lunar Radiometer Experiment onboard the Lunar Reconnaissance Orbiter investigated the global solar reflectance and mid-IR irradiance. These infrared measurements contribute to the quantitative description of the thermophysical properties of the superficial lunar regolith media. Chinese probes, Chang'e-1 and Chang'e-2, carried four-channel microwave radiometers to observe the microwave thermal emission of the lunar regolith media, which may provide information on superficial dielectric properties of the lunar surface. These advances created a foundation for the millimeter channel observation of the lunar surface. In this study, a real-time model of the sub-solar position and total irradiance of the lunar surface was developed. The altitude of FY-4M is 35800 km. The distance between the Moon and the Earth is between 363400 km (perigee) and 405400 km (apogee). This large distance enables nadir observation from the FY-4M radiometer toward the center region of the lunar equator. The observation beam angle ranges from 0.097 degrees to 0.027 degrees. The diameters of the observation regions at different channels are 750 km (55 GHz), 480 km (89, 118 GHz), 300 km (166, 183 GHz), and 210 km (425 GHz) at apogee. Based on the surface albedo derived from the Clementine data and the constrained thermophysical parameters of the lunar regolith media obtained from the Diviner infrared brightness temperature, the one-dimensional thermal transfer equation is solved to obtain the physical temperature profile of the lunar regolith media. Using the 37-GHz brightness temperature from Chang'e-2 observations, the loss tangent of the regolith media is inverted. Using the fluctuation dissipation theorem, the brightness temperature of the lunar surface in FY-4M millimeter channels is calculated. The thermophysical profile of the regolith can be validated using the Diviner infrared brightness temperature data. The calculated temperature at a depth of 1.3 m is consistent with the measurements obtained in the Apollo heat flow experiment. The surface temperature and millimeter brightness temperature on the lunar equator (0 degrees N, 0 degrees E) during the entire year of 2010 are simulated. The peak value of the brightness temperature is attained after that of the surface physical temperature peak value. In the low frequency channel, the penetration depth increases, its peak value is typically small, and the peak appears later. This study thus presents an effective model for FY-4M calibration and data analysis.

In-Flight Calibration of Visible and Near-Infrared Imaging Spectrometer (VNIS) Onboard Chang'E-4 Unmanned Lunar Rover

In-situ mapping of iron and titanium with the visible and near-infrared image spectrometer (VNIS) along the Yutu-2 rover traverse on the farside of the moon

Using the Moon for On-Orbit Absolute Radiometric Calibration of GaoFen-4 PMS

FY-3D MERSI On-Orbit Radiometric Calibration from the Lunar View

Calibration of a multichannel millimeter wave radiometer of FY-4M based on the real-time brightness temperature along the lunar equator

dsDusty Mafic Rocks Along the Path of Chang'E‐4 Rover: Initial Analysis of the Image Cubes of the Onboard Visible and Near‐infrared Imaging Spectrometer

Absolute Calibration of the Chang’E-1 IIM Camera and Its Preliminary Application

Calibration of the space-borne microwave humidity sounder based on real-time thermal emission from lunar surface

CALIBRATION OF MULTI-CHANNEL MILLIMETER-WAVE RADIOMETERS OF GEOSYNCHRONOUS FY-4M USING BRIGHTNESS TEMPERATURE OF THE LUNAR SURFACE AT MILLIMETER CHANNELS

Research on Photometric Calibration and Reflectance Calculation of CE-1 IIS Data

Lunar surface radiation brightness temperature simulation for FY-4 lunar calibration

Vicarious Radiometric Calibration of Ocean Color Bands for FY-3D/MERSI-II at Lake Qinghai, China

Absolute Radiometric Calibration of PMS2 Onboard Jilin-1 GP02 Satellite Using the Moon

On-Orbit Vicarious Radiometric Calibration and Validation of ZY1-02E Thermal Infrared Sensor

Lunar Phase Function Oversampling Correction Method for FY3D/MERSI On-Orbit Calibration

In-orbit lunar imaging and analysis for optical remote sensing satellite

On-orbit calibration of soft X-ray detector on Chang'E-2 satellite

Simulation Study of the Lunar Spectral Irradiances and the Earth-Based Moon Observation Geometry

Initial In-Flight Spectral Calibration of the Near-Infrared Spectra Acquired by the MarSCoDe Onboard the Zhurong Rover

Evaluation of the Radiometric Calibration of ZY1-02E Thermal Infrared Data

Applications of AOTF Spectrometers in In Situ Lunar Measurements