Abstract:Transcritical CO2 system has been widely used in many fields to provide heating and cooling capabilities, and optimizing the structure of the gas cooler is an effective way to improve its performance. This paper presents a theoretical and experimental study of a spirally fluted tube-in-tube heat exchanger used as a gas cooler in a transcritical CO2 heat pump. The theoretical research uses numerical simulations to investigate the flow and heat transfer characteristics. The effect of the different CO2 mass flow rates, inlet pressure, and temperature on the performance of the spirally fluted gas cooler is evaluated and analyzed. The simulation results show that the spirally fluted structure can significantly improve the heat transfer performance of the CO2 side compared to the flat tube, which indicates that the spirally fluted gas cooler could be an effective way to enhance the operating performance of the transcritical CO2 system. Then experimental research is conducted in a transcritical CO2 heat pump prototype to validate the functional performance of the spirally fluted gas cooler. The effect of the different CO2 mass flow rates, inlet pressure and temperature, and the different water inlet and outlet temperatures on the performance of the spirally fluted gas cooler in the prototype are tested. The heat exchanger efficiency - number of transfer units (epsilon-NTU) method is employed to analyze the operating performance based on the experimental data. In addition, the exergy loss method is used to quantitatively evaluate the side-effect of the large pressure drop by the spirally fluted structure. Both the theoretical and experimental results show that the spirally fluted tube gas cooler can significantly improve the performance of the transcritical CO2 system. Besides, a heat transfer and friction coefficient correlation are established based on the experimental data for future research guidance.

Experimental and Theoretical Study on Work Conversion and Heat Transfer of R290 Linear Compressor

Heat Transfer Simulation for Reciprocating Compressor with Experimental Validation

Experimental Study on New Variable Composition Heat Pump System

Proposal and thermodynamic analysis of an ejection-compression refrigeration cycle driven by low-grade heat

Performance Research and Improvement of Ultra-High-speed R290 Rotary Compressor

Experimental Performance of a Heat Pump Driven by Vapor Injection Linear Compressor

Thermodynamic Performance and Compression Characteristics Analysis of Low GWP Refrigerant in Compressors: Experimental Investigation and 0-D/3-D Simulation

Experimental Study on P-V Diagram and Valve Displacement of A Hc290 Rotary Compressor

Experimental Study Of The Compressor In A R410a Heat Pump Water Heater System

Optimization analysis of linear compressor using R290 for capacity-modulation performance improvement

Performance Analysis of Linear Compressor Using R290 for Commercial Refrigerator

Experimental study and model optimization of thermodynamic performance of a single screw water vapor compressor

Performance and Optimization Study of R290 As Alternative Refrigerant for R22 in Low Temperature Heat Pump System

Experimental Investigation on Off-Design Characteristics of R290 Rolling Piston Compressor

Experimental Study of Heat Transfer Effect on Oil-Free Scroll Air Compressor

Experimental Study on Performance Enhancement of Heat Pump With Screw Compressor

Theoretical and Experimental Studies for a Transcritical CO2 Heat Pump with Spirally Fluted Tube Gas Cooler

Experimental Investigation on the Scroll Refrigeration Compressor with External Cooling

Performance Evaluation on the In-Cylinder Heat Transfer of a Reciprocating Compressor Using CO 2 As a Working Fluid

Experimental Study on Performance of the Trans-Critical CO2 Heat Pump with Flash Tank Vapor Injection at Variable Revolution Ratio Conditions

Experimental Study on the Performance of Water Source Trans-Critical CO2 Heat Pump Water Heater