Abstract:This study explores the application of a wall-attached ferrofluid film to decrease skin-friction drag in turbulent channel flow. We conduct experiments using water as a working fluid in a turbulent channel flow set-up, where one wall is coated with a ferrofluid layer held in place by external permanent magnets. Depending on the flow conditions, the interface between the two fluids is observed to form unstable travelling waves. While ferrofluid coating has been previously employed in laminar and moderately turbulent flows (Reynolds number ) to reduce drag by creating a slip condition at the fluid interface, its effectiveness in fully developed turbulent conditions, particularly when the interface exhibits instability, remains uncertain. Our primary objective is to assess the effectiveness of ferrofluid coating in reducing turbulent drag with particular focus on scenarios when the ferrofluid layer forms unstable waves. To achieve this, we measure flow velocity using two-dimensional particle tracking velocimetry (2D-PTV), and the interface contour between the fluids is determined using an interface tracking algorithm. Our results reveal the significant potential of ferrofluid coating for drag reduction, even in scenarios where the interface between the surrounding fluid and ferrofluid exhibits instability, with observed drag reduction rates up to 95 %. In particular, waves with an amplitude significantly smaller than a viscous length scale positively contribute to drag reduction, while larger waves are detrimental, because of induced turbulent fluctuations. However, for the latter case, slip outcompetes the extra turbulence so that drag is still reduced.

Flexible Coating Reduces Drag

Drag Reduction Via Turbulent Boundary Layer Flow Control

Drag reduction using a self-adaptive flexible coating

Dynamics of Two-Dimensional Flow Around a Circular Cylinder with Flexible Filaments Attached

DARG VARIATION OF A COUPLED RIGID-FLEXIBLE SYSTEM IN WIND TUNNEL EXPERIMENTS

Numerical Study of Flow Control Via the Interaction Between a Circular Cylinder and a Flexible Plate

“Fluid Roller Bearing” Effect and Flow Control

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Superhydrophobic surfaces to reduce form drag in turbulent separated flows

An innovative study on low surface energy micro-nano coatings with multilevel structures for laminar flow design

Drag reduction and antifouling of a spontaneous fast moving air film

Formation Mechanism of Polymer Coating for Drag Reduction

Shape Deformation and Drag Variation of a Coupled Rigid-Flexible System in a Flowing Soap Film.

Fluid-Solid Interfacial Properties and Drag-Reducing Characterization of the Flexible Conical Microstructured Film Inspired by the Streamlined Body Surface of the Pufferfish

Research on Drag Reduction for Flexible Skin Inspired by Bionics

Drag reduction study of a microfiber-coated cylinder

Investigation of the drag reduction performance of bionic flexible coating

Deep reinforcement learning-based active flow control of an elliptical cylinder: transitioning from an elliptical cylinder to a circular cylinder and a flat plate

Coherent Structures in Wall Turbulence and Mechanism for Drag Reduction Control

Drag reduction utilizing a wall-attached ferrofluid film in turbulent channel flow

Turbulent Drag Reduction by Traveling Wave of Flexible Wall