Abstract:Many robotic systems, like surgical robots, robotic hands, and exoskeleton robots, use cable passing through conduits to actuate remote instruments. Cable actuation simplifies the design and allows the actuator to be located at a convenient location, away from the end effector. However, nonlinear frictions between the cable and the conduit account formajor losses in tension transmission across the cable, and a model is needed to characterize their effects in order to analyze and compensate for them. Although some models have been proposed in the literature, they are lumped parameter based and restricted to the very special case of a single cable with constant conduit curvature and constant pretension across the cable only. This paper proposes a mathematically rigorous distributed parameter model for cable-conduit actuation with any curvature and initial tension profile across the cable. The model, which is described by a set of partial differential equations in the continuous time-domain, is also discretized for the effective numerical simulation of the cable motion and tension transmission across the cable. Unlike the existing lumped-parameter-based models, the resultant discretized model enables one to accurately simulate the partial-moving/partial-sticking cable motion of the cable-conduit actuation with any curvature and initial tension profile. The model is further extended to cable-conduit actuation in pull-pull configuration using a pair of cables. Various simulations results are presented to reveal the unique phenomena like backlash, cable slacking, interaction between the two cables, and other nonlinear behaviors associated with the cable conduits in pull-pull configuration. These results are verified by experiments using two dc motors coupled with a cable-conduit pair. The experimental setup has been prepared to emulate a typical cable-actuated robotic system. Experimental results are compared with the simulations and various implications are discussed.

Modeling and Analysis of a Cable-pulley Actuated Lifting System

Dynamics Simulation of the Hoisting Cable of Single Cable Winding Hoisting Device

An efficient model for dynamic analysis and simulation of cable-pulley systems with time-varying cable lengths

Research on Dynamic Control Model of Multi-Scenario Synchronization in Aircraft Suspension Lifting System

Modeling and H∞ Position Control of a Spreader in the Gantry Crane

Dynamic Modeling and Control of a Cable-Driven Parallel Mechanism with a Spring Spine

Modeling of a closed loop cable-conduit transmission system

Dynamic Modeling and Analysis of Cable Parallel Manipulator for Dual Automobile Cranes during Luffing Motion

Dynamic Analysis and Control for Cable-supported Flexible Structure

Dynamic Modeling And Analysis Of Three-Dimensional Slack Cables With Application To Elevator Traveling Cables

Modeling of transmission characteristics across a cable- conduit system

Three-dimensional dynamic modeling and analysis of moving elevator traveling cables

MODELING, DYNAMICS AND CONTROL OF CABLE SYSTEMS

Dynamics Simulation of Large Tower Structure Lifting Process Based on CABLE Modeling

Modeling and Workplace Analysis of 3t Cable-Driven Parallel Manipulator

Dynamic Analysis of Cable-Driven Humanoid Arm Based on Lagrange’s Equation

Dynamics and Nonlinear Control of a Cable-driven Parallel Robot

Vibrations Analysis of Cable-Harnessed Plates: Continuum Modeling and Experimental Validation

Statics and dynamics of pulley-driven tensegrity structures with sliding cable modeling

Dynamic Modeling of Helicopter-Slung Load System under the Flexible Sling Hypothesis

Tension Optimization of a Cable-Driven Coupling Manipulator Based on Robot Dynamics with Cable Elasticity.