Abstract:Shake table test is one of the most important manners for the performance evaluation of structures under strong earthquakes and for the verification of refined numerical simulation methods. To this end, in the present paper, shake table tests on two concrete shear wall model structures, together with the tests of complete uniaxial compressive constitutive curves of concrete, were carried out. The purpose of the tests is to provide quantitative benchmark results for the verification and improvement of refined multi-scale numerical simulation method for structures exhibiting strong non-linear behaviors. Three important properties were carefully taken into account in the tests, including: (1) The scale ratio should not be too small so that detailed local damage could be revealed and the experimental results could serve as benchmark data; (2) The model structures should exhibit strong nonlinear behaviors but the accumulated damage between load cases should be avoided; (3) Concrete specimens should be simultaneously tested to capture the complete stress-strain curves rather than only the two parameters (the compressive strength and Young's modulus); and (4) The unavoidable randomness involved in concrete structures should be quantified. To satisfy the above requirements, some special measures were taken, including: e.g., vertical prestressed tendons were exerted to make up the inadequacy of gravitational compression due to the inadequate density scaling; strong earthquake inputs were input directly after linear stage tests so that strong non-linearity occurred directly in the model structures, similar to practical structures subjected to real earthquakes; and 54 concrete specimens were tested for constitutive law and two model structures were tested for comparison and characterizing the effects of randomness. The experimental results, including frequencies and vibrational modes, the observed damage distributions and the responses of model structures are elaborately delineated and discussed in the paper. In particular, besides flexural-shear damage, compressive damage was also observed in the test model structures. This is frequently observed in practical earthquake damage but is usually not exhibited in most shake table tests. Such detailed information together with observed data provided valuable benchmark data for the verification and improvement of refined numerical simulation method, which will be detailed in other papers.

Nonlinear Modeling of the Ten-Story RC Building Structure of 2015 E-Defense Shaking Table Tests

Nonlinear Finite-Element Analysis of the Seismic Behavior of RC Column–Steel Beam Connections with Shear Failure Mode

Experimental research on a large scale RC frame model subjected to sudden corner column removal

Damage Inference and Residual Capacity Assessment for an E-Defense 2018 Ten-Story RC Test Structure

Dynamic Inelastic Numerical Simulation On A Shaking Table Test Of A Full Scale Steel Moment Frame

Shake Table Test for the Collapse Investigation of A Typical Multi-Story Reinforced Concrete Frame Structure in the Meizoseismal Area

Shaking Table Test and Numerical Simulation on a Vertical Hybrid Structure under Seismic Excitation

Shaking table test of two full-scale models of S350 cold-formed thin-walled steel framing buildings

Shaking table tests and numerical analyses of an RC coupled wall structure with replaceable coupling beams

Shaking table model test and numerical analysis of a long-span cantilevered structure

Shaking table tests of RC frames and development of design-oriented time history analysis method

Shaking table tests and numerical analysis of RC coupled shear wall structure with hybrid replaceable coupling beams

Modeling of non-ductile RC structure under near-fault ground motions: A nonlinear finite element analysis

A Shake Table Test Study of Reinforced Concrete Shear Wall Model Structures Exhibiting Strong Non-Linear Behaviors

Finite-Element Model Updating for Assessment of Progressive Damage in a 3-Story Infilled RC Frame

Shaking Table Test on the Collapse Process of A Three-Story Reinforced Concrete Frame Structure

Development of a numerical model for RC columns considering seismic dynamic effect and different failure modes

Shaking Table Test and Numerical Simulation of an RC Frame‐core Tube Structure for Earthquake‐induced Collapse

Modeling inelastic behavior of U-shaped walls using multi-layer shell element: assessment at both global and local levels

A Practical Multi-cross-line Model for Simulating Nonlinear Cyclic Behavior of Reinforced Concrete Shear Wall in Super High-Rise Buildings

Shake Table Testing of A Multi-Tower Connected Hybrid Structure