Abstract:Twinning is an important deformation mechanism for Mg alloys, which is intimately related to their mechanical behaviors, such as yield strength, strain hardening, ductility and so on. Therefore, a fundamental understanding of twinning behavior and mechanism under various conditions is essential for improving the mechanical properties of Mg alloys. This study aims to extend understanding the mechanism of {10–12} twin variant selection and twin patterns in compression of basal textured AZ31 Mg alloy sheet along transverse direction. Various twin patterns such as independent or intersecting multi-twins in a grain, paired twins in two neighboring grains, and twin chains across many grains were observed in the 3% compressed AZ31 sample. The variant selection of {10–12} twins in the various twin patterns were studied by a combined analysis of Schmid factor and strain compatibility factor, m′. Multiple twin variants can be formed in a grain and the non-Schmid twin variant could be induced by the impingement of a neighboring twin at grain boundary. Paired {10–12} twins are likely formed when the Schmid factors of both twins and their strain compatibility factor are very high. The paired twins can propagate throughout the grains and transfer to more neighboring grains (termed as twin–twin transfer behavior). Such continuous twin–twin transfer behavior across more than three neighboring grains results in the formation of twin chains. In addition, strain accommodation among the different twin variants in the same grain, and the orientation relationship between the paired twins and their common grain boundary direction are discussed. A comprehensive understanding of the twin patterns and variant selection was achieved by such a combined analysis of Schmid factor and strain accommodation factor.

The Quantitative Study of Twinning Behavior During Compression of Mg-Sn Alloy Containing Prismatic Precipitates

Twinning Behaviors of Mg-Sn Alloy with Basal or Prismatic Mg2Sn

Atomistic and Theoretical Insights on Nanoprecipitates-Controlled Strengthening Behavior for Optimum Mechanical Performance in Nanotwinned NiCoCr Alloys

A Study of {10-12} Twinning Activity Associated with Stress State in Mg-3Al-1Zn Alloy during Compression

On the interaction of precipitates and tensile twins in magnesium alloys

Three-dimensional study of grain scale tensile twinning activity in Mg: A combination of microstructure characterization and mechanical modeling

Influence of precipitation on tension and compression twinning in Mg-6.5Zn alloy

Twin-twin Geometric Structure Effect on the Twinning Behavior of an Mg-4Y-3Nd-2Sm-0.5Zr Alloy Traced by Quasi-in-situ EBSD

Twin recrystallization mechanisms in a high strain rate compressed Mg-Zn alloy

Strengthening Against {101¯2} Twinning by Discontinuous and Continuous Precipitate in a Strongly Textured Mg-9Al Alloy

The Precipitation Behavior of a Pretwinned Mg–6Al–1Zn Alloy and the Effect on Subsequent Deformation

Effect of Sm on Twinning Behavior of Mg-Gd-Y-Zr Alloy at Room Temperature Compression

Three-dimensional study of grain scale tensile twinning activity in magnesium: A combination of microstructure characterization and mechanical modeling

Understanding of variant selection and twin patterns in compressed Mg alloy sheets via combined analysis of Schmid factor and strain compatibility factor

Understanding the interaction of {10-12} twins and Mg17Al12 precipitates in magnesium alloys via high-resolution electron microscopy

Study of Twinning Behavior of Powder Metallurgy Ti-Si Alloy by Interrupted In-Situ Tensile Tests

Pre-strain Effect on Twinning and De-Twinning Behaviors of Mg-3Li Alloy Traced by Quasi-in-situ EBSD

Abnormal Twinning Behavior Induced by Local Stress in Magnesium

The Effect of Twin–twin Interaction in Mg 3al 1zn Alloy During Compression

Strengthening Against {10(1)Over-Bar2} Twinning By Discontinuous And Continuous Precipitate In A Strongly Textured Mg-9al Alloy

The Quantitative Regulation of Basal and Prismatic Mg2Sn to Strengthen Mg-Sn Alloys