Abstract:With the ongoing promotion and adoption of electric vehicles, intelligent and connected technologies have been continuously advancing. Electrical control systems implemented in electric vehicles have emerged as a critical research direction. Various drive-by-wire chassis systems, including drive-by-wire driving and braking systems and steer-by-wire systems, are extensively employed in vehicles. Concurrently, unavoidable issues such as conflicting control system objectives and execution system interference emerge, positioning integrated chassis control as an effective solution to these challenges. This paper proposes a model predictive control-based longitudinal dynamics integrated chassis control system for pure electric commercial vehicles equipped with electro–mechanical brake (EMB) systems, centralized drive, and distributed braking. This system integrates acceleration slip regulation (ASR), a braking force distribution system, an anti-lock braking system (ABS), and a direct yaw moment control system (DYC). This paper first analyzes and models the key components of the vehicle. Then, based on model predictive control (MPC), it develops a controller model for integrated stability with double-layer torque distribution. The required driving and braking torque for each wheel are calculated according to the actual and desired motion states of the vehicle and applied to the corresponding actuators. Finally, the effectiveness of this strategy is verified through simulation results from Matlab/Simulink. The simulation shows that the braking deceleration of the braking condition is increased by 32% on average, and the braking distance is reduced by 15%. The driving condition can enter the smooth driving faster, and the time is reduced by 1.5 s~5 s. The lateral stability parameters are also very much improved compared with the uncontrolled vehicles.

Stability Analysis Based on the United Model Consists of the PMSM Control System and the Vehicle Dynamics Model

Field-circuit Coupled Design and Analysis for Permanent Magnet Synchronous Motor System Used in Electric Vehicles

Accurate Simulation and Analysis of PMSM Vector Control System

Stability Analysis of Speed and Multi-Factor Simplification in Port Controlled Dissipative Hamiltonian Permanent Magnet Synchronous Motor

Research of Stability Control of Distributed Drive Electric Vehicles under Motor Failure Modes

Driving System Stability Analysis and Improving of IPMSM

Stability Analysis of Explicit Model Prediction Method under Vector Control of Permanent Magnet Synchronous Motor

Stability Control Strategy Design and Experiment of Distributed Electric Drive Vehicle

Study on Stability Control of 4wd Ev Based on Sliding Mode Control

Modeling and Simulation of Permanent Magnet Synchronous Motor Optimization Control System

An Improved Adaptive Fuzzy PID Controller for PMSM and a Novel Stability Analysis Method

Research on Coordinated Control Method of PMSMs Traction System in EMU Train

A Combined Simulation of High-Speed Train Permanent Magnet Traction System Using Dynamic Reluctance Mesh Model and Simulink

The Simulation of Permanent Magnet Synchronous Motor Control System for Electric Vehicle

Parametric Stability Analysis and Adaptive Control of Permanent Magnet Synchronous Motor

Non-fragile event-triggered control for PMSM model with stochastic disturbances

Research on the simulation model of electric vehicle parameters based on PMSM-AMT

Integrated Longitudinal and Lateral Vehicle Stability Control for Extreme Conditions With Safety Dynamic Requirements Analysis

Simulation of PMSM Vector Control System Based on Matlab/Simulink

Modeling and analysis of vehicle stability region based on Lyapunov and coordinated control

An NMPC-Based Integrated Longitudinal and Lateral Vehicle Stability Control Based on the Double-Layer Torque Distribution