Abstract:A custom-built gas cluster ion source with energy up to 50 keV is constructed, and Ar, CO2, N-2, and O-2 are used as the working gases. The clusters are formed by a metal supersonic conical nozzle with critical diameter in a range of 65-135 mu m and a cone angle of 14 degrees. The nozzle is powered in the pulsed mode, which improves the pumping conditions, and also makes it possible to increase the gas pressure in the stagnation zone to 15 atm and thereby obtain larger clusters. Based on the principle of ultrasonic expansion, gas cluster ions with an average size of 3000 atoms are obtained. The cluster beam current of 50 mu A is obtained. The Ar cluster beam, which is less reactive, is used for treating surface, namely, surface smoothing and formation of self-assembled nanostructures. The Ar cluster bombardment perpendicular to the surface of the substrate is used to demonstrate the smoothing of the surface of Si wafers, Ti coating, and Au film. For the initial Si wafer, its root-mean-square (RMS) roughness of 1.92 nm decreases down to 0.5 nm after cluster beam treatment. The cleaning effect of the cluster beam is also observed very well. The one-dimensional (1D) isotropic power spectral density of the Si surface topography before and after smoothing are also discussed. The off-normal irradiation Ar cluster beam is also used to form self-assembled surface nanoripple arrays on the surface of flat ZnO single crystal substrates. The ripple formation is observed when the incident angle of the cluster beam is in a range of 30 degrees-60 degrees. The process of nanoripple fabrication is significantly governed by the cluster beam incident angle, energy and dose. The nano-ripples formed on the flat substrates remain eolian sand ripples and their formation starts at the incident angle of 30 degrees. The most developed nanoripples are observed at the incident angle within a range of 45 degrees-60 degrees. The surface morphology and characteristic distribution of the nano-structures on the flat ZnO substrate are also analyzed by the two-dimensional (2D) power spectral density function. Next, Ar cluster beam is used for irradiating the ZnO nanorod arrays grown on the Si substrate. Due to various angles between the nanorod's axis and the substrate normal, the conditions of the ripple formation on the nanorod facets are also realized. The dependence of wavelength on the accelerating voltage of the cluster ions and the dose are studied. Similar dependence of wavelength on accelerating voltage and dose are found for nanorods. Comparing with the flat ZnO surface, nanoripples on the ZnO nanorod faces at high irradiation doses demonstrate an ordering effect, and morphology of the ripples resembles that of more parallel steps rather than eolian ripples.

Quantifying the Surface Modification Induced by the Argon Cluster Ion Bombardment of KGd(WO4)2: Nd Single Crystal

Microstructural and Chemical Effects of the Argon Cluster Bombardment on a Single Crystal KGd(WO4)2 Surface

Studies on Surface Damage Induced by Ion Bombardment

Anomalous Sputtering of the Lithium Triborate Single Crystal Surface by Argon Cluster Ions

Surface damage produced by 20 keV Ga bombardment of Ge(001)

The Influence of Argon Cluster Ion Bombardment on the Characteristics of AlN Films on Glass-Ceramics and Si Substrates

Borate nonlinear optical single crystal surface finishing by argon cluster ion sputtering

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Surface modification by high-energy heavy-ion irradiation in various crystalline ZnO facets

Molecular Dynamics Simulation of Atomic Beam Bombardment on a Solid Surface

Surface defects created by 20keV Xe ion irradiation of Ge(111)

On the classification and quantification of crystal defects after energetic bombardment by machine learned molecular dynamics simulations

Enhanced Sputtering Yield of Nanostructured Samples under Ar+ Cluster Bombardment

Damage Produced on GaN Surface by Highly Charged Krq+ Irradiation

The Effect of Crystal Orientation on the Behavior of a Polycrystalline Tungsten Surface under Focused Ga+ Ion Bombardment

Atomistic simulation of structural damage during ion irradiation of iron single crystals

Study of Morphological Feature and Mechanism of Potassium Dihydrogen Phosphate Surface Damage under a 351 Nm Nanosecond Laser.

Design and Application of Gas Cluster Accelerator for Surface Smoothing and Nanostructures Formation

Research on surface oxidizing process of Nd thin film target

Development of a Gas Cluster Ion Source and Its Application for Surface Treatment

Real-time Observation of Disintegration Processes Within Argon Clusters Ionized by a Hard-X-ray Pulse of Moderate Fluence