Abstract:To improve the casting quality as well as the casting efficiency during the casting process, the effect of the interaction of process parameters and system structural parameters on the shrinkage volume and efficiency of the casting was investigated in this paper by using the response surface method for the simulation prediction of A356 alloy sand casting. The relationship between variables and response (shrinkage volume, solidification time) was established by Box-Behnken Design with pouring temperature (650–710 °C), mold preheating temperature (200–300 °C), width/thickness ratio of cross-section of sprue (1.2–1.5), width/thickness ratio of inner sprue section (2–4) and length/diameter ratio of straight sprue (1.5–2.5) as variables by the response surface method. The results are then optimized, and the optimal solution is selected by the NSGA-II algorithm and TOPSIS method. The results show that the changes in the cavities of the optimized and improved pouring system enhance the flow of the metal fluid and make the filling more complete. The gentle cooling of temperature is conducive to heat dissipation and layer-by-layer sequential solidification, which can effectively eliminate the casting's internal shrinkage loosening and shrinkage holes defects, thus forming a dense casting with good performance. After solving the optimized parameters and improving the pouring system, the solidification time (integrated solidification time) was reduced from 129.24 to 88.10s, and the shrinkage volume was reduced from 9.68 to 4.06 cm 3 .

Analysis of the casting process design of the support table

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Analyzing the main casting defects and their mold parameters

Design and Optimization of Casting Technology for Steel Beam

The Research and Development of Integrating Database in Casting Process

Cooling Control for Castings by Adopting Skeletal Sand Mold Design

Modeling and Simulation of the Casting Process with Skeletal Sand Mold

Brief analysis on mold design and forging process of a typical forging product

Carbon Emission Modeling of Sand Casting Based on Process Carbon Sources

Die-Casting Die Design Based on the Application of Cae Simulation

Design and Analysis of Hot Core Box Mold for New Energy Vehicle Motor Shell

Optimization design of support structure based on 3D printing technology

The molding analysis of automobile parts using the die-casting system

Optimization of Casting System Structure Based on Genetic Algorithm for A356 Casting Quality Prediction

Mold Design and Forming Process Analysis of Box Parts

Low pressure casting technology and forming process analysis of metal mold based on ProCAST FEA procedure

Precisely forming process and mold design of support shaft

Study on a CAD/CAE system of die casting

Microstructure phase analysis and process optimization of ZL205A metal mold casting

Research and Computer Modeling of the Process of Casting Parts Alloys