Postannealed (gain)2o3 Films Deposited by Sputtering for Ultraviolet Photodetection

Fabi Zhang,Tingbo He,Juan Zhou,Haizheng Hu,Daoyou Guo,Haiou Li,Xinpeng Liu,Peihua Wangyang,Tangyou Sun
DOI: https://doi.org/10.1021/acsaelm.2c00704
IF: 4.494
2022-01-01
ACS Applied Electronic Materials
Abstract:In this work, we demonstrated that thermal-annealed (GaIn)(2)O-3 films deposited by sputtering can be used for UV detector applications. X-ray diffractometer measurement shows that the (GaIn)(2)O(3 )film annealed at 900 degrees C possesses the best crystal orientation. All annealed (GaIn)(2)O(3 )films have a high transmittance of over 80% in the visible light region measured by a spectrometer. The photoresponse of the (GaIn)(2)O(3 )film-based photodetectors was affected by the annealing temperature. A film annealed at 800 degrees C possesses high photosensitivity (2.5 x 10(4)), high photoresponsivity (16.9 A/W), as well as high detectivity (3.11 x 10(11) Hz(1/2) W-1) at 5 V bias under 254 nm illumination. The photoresponsivity has been improved through thermal annealing. However, further increasing the annealing temperature from 700 to 1100 degrees C decreased the photoresponsivity. The decay/rise time reduced obviously after thermal annealing. Both the variation of photoresponsivity and response time should concern with the variation of oxygen vacancies. This work is helpful for the preparation of a (GaIn)(2)O-3-based ultraviolet photodetector and the improvement of its response speed and responsivity.
What problem does this paper attempt to address?