Abstract:The deformation of the overlying pipeline caused by the soil tunnel excavation cannot be ignored in the case of the small spacing between the pipeline and the tunnel. Based on the rigid bar method, the pipeline-soil interaction model was established, with the simply supported beam as the basic system, and the loads acting on the pipeline by the soil are considered to be linearly distributed. Calculation methods for continuous and discontinuous pipeline deformations were established. The results calculated by the proposed method agree well with the experimental data of centrifuge tests and field data. Parametric study on the effect of the volume loss ( η = 1%, 2%,3 %), rotational stiffness ( β 0 = 4.47 × 10 6 N ⋅ m/rad, 4.47 × 10 8 N ⋅ m/rad, 4.47 × 10 10 N ⋅ m/rad), ratio of pipeline section length to inflection point of soil settlement curve ( L / i s = 0.5, 1.0, 1.5, 2.0) and soil elastic modulus ( E = 10 MPa, 30 MPa, 50 MPa) on the deflection and joint rotation angle of the discontinuous pipeline were carried out. Results show that: (1) the maximum pipeline deflection and the maximum rotation angle of the joint increase as η increases and decrease as β 0 increases; (2) in the "odd" case, the maximum pipeline deflection and the maximum rotation angle of the joint first increase and then decrease as L / i s increases, reaching a peak at L / i s = 1.5, while in the "even" case, the maximum pipeline deflection decreases as L / i s increases and the maximum rotation angle of the joint first increases and then decreases as L / i s increases; (3) in the "odd" case, the maximum pipeline deflection and the maximum angle of rotation of the joint decrease as E increases, while the opposite trend is observed in the "even" case. Additionally, the maximum pipeline deflection and the maximum rotation angle of the joint are always greater in the "odd" case than that in the "even" case.

Relationship Between Water Injection Volume and Liquid Injection Pressure under the Condition of Pipeline Deformation

Improved Model for Contaminant Intrusion Induced by Negative Pressure Events in Water Distribution Systems

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Analysis of Pipeline Strain under Liquid Storage Pressure

Strain Analysis of Acrylic Pipe under Liquid Storage Pressure

A Numerical Study on Long-Term Water Injection Procedure and the Corresponding Formation Property Variation

Mechanical Behaviors and Soil Gap Formation of Existing Pipeline Based on Large-Deformation Theory

Effect of the Y/T on the Burst Pressure for Corroded Pipelines with High Strength

Prediction for Response of Adjacent Pipelines Induced by Pipe Jacking Construction

Simulation and experimental verification on fluid-structure interaction of T-shaped pressure pipeline

Experimental Investigation on the Wave-Induced Pore Pressure Around Shallowly Embedded Pipelines

Leakage characteristics of plug flow in the case of pipe leakage

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Numerical and Experimental Investigation on Leak Discharge-Pressure Relationship for Linear Elastic Deforming Pipes

An Assessment of the Residual Stress of Pipelines Subjected to Localized Large Deformations

Analytical Analysis of Influence of Dewatering on Adjacent Pipelines Based on Pasternak Foundation

Influence of Temperature and Hydrostatic Pressure to the Deformation of Tank

A new approach for evaluating continuous and discontinuous pipeline deformation induced by soil tunnel excavation

Leak Simulation for Liquid Pipelines

Analytical solution of overlying pipe deformation caused by tunnel excavation based on Pasternak foundation model

Effect of High Pressure on Severe Slugging and Multiphase Flow Pattern Transition in a Long Pipeline-Riser System