Abstract:In order to achieve a high-precision synchronous detection of two different refractive index (RI) analytes, a D-type surface plasmon resonance (SPR) photonic crystal fiber (PCF) RI sensor based on two channels is designed in this paper. The sensor uses a D-shaped planar region of the PCF and a large circular air hole below the core as the sensing channels. Surface plasmon resonance is induced by applying a coating of gold film on the surface. The full-vector finite-element method (FEM) is used to optimize the structural parameters of the optical fiber, and the sensing characteristics are studied, including wavelength sensitivity, RI resolution, full width at half maximum (FWHM), figure of merit (FOM), and signal-to-noise ratio (SNR). The results show that the channel 1 (Ch 1) can achieve RI detection of 1.36-1.39 in the wavelength range of 1500-2600 nm, and the channel 2 (Ch 2) can achieve RI detection of 1.46-1.57 in the wavelength range of 2100-3000 nm. The two sensing channels can detect independently or simultaneously measure two analytes with different RIs. The maximum wavelength sensitivity of the sensor can reach 30,000 nm/RIU in Channel 1 and 9900 nm/RIU in Channel 2. The RI resolutions of the two channels are 3.54 × 10-6 RIU and 10.88 × 10-6 RIU, respectively. Therefore, the sensor realizes dual-channel high- and low-RI synchronous detection in the ultra-long wavelength band from near-infrared to mid-infrared and achieves an ultra-wide RI detection range and ultra-high wavelength sensitivity. The sensor has a wide application prospect in the fields of chemical detection, biomedical sensing, and water environment monitoring.

Dual-channel Refractive Index Sensor Based on Coupling Between LP01 and LP11 Modes in the Tapered Hole-Assisted Dual-Core Fiber.

Optofluidic Refractive Index Sensor Based on Partial Reflection

High Sensitivity Refractive Index Sensor Based On Tapered Thin-Core Fiber

Dual Mach–Zehnder Interferometer Based on Side-Hole Fiber for High-Sensitivity Refractive Index Sensing

Multi-Point Fiber-Optic Refractive Index Sensor by Using Coreless Fibers

Refractive index sensors based on the fused tapered special multi-mode fiber

Fiber-Optic Refractive Index Sensor Based on Multi-Tapered SMS Fiber Structure

Optical Refractive-Index Sensor Based on Dual Fiber-Bragg Gratings Interposed with a Multimode-Fiber Taper

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

Fiber Refractive Index Sensor Based on Dual Polarized Mach–Zehnder Interference Caused by a Single-Mode Fiber Loop

Fiber-tip-integrated High-sensitivity Refractive Index and High-precision Liquid Level Sensor Based on Surface Plasmon Resonance

An Interferometric Dual Microfiber Refractive Index Sensor via Tapering of Femtosecond Laser Perforated Optical Fiber

High-Sensitivity Refractive Index Sensor with Dual-Channel Based on Surface Plasmon Resonance Photonic Crystal Fiber

High Sensitivity Refractive Index Sensor based on a Tapered Single-mode-Multimode-Single-mode Fiber Structure

Highly sensitive refractive index sensor with fiber in-line Fabry-Perot interferometers based on vernier effect

Novel Intensity-demodulated Fiber-optic Refractive Index Sensor Based on Splicing Point Tapered Fiber

Slight-Offset Tapered Multimode Fiber with High Sensitivity for Low Refractive Index Range

A Reflective Fiber-Optic Refractive Index Sensor Based on Multimode Interference in A Coreless Silica Fiber

Refractive Index Sensors Based on a Chirped Core Long-Period Fiber Grating

Sensitive Enhanced Refractive Index Sensor Based on Series Tapered Thin-Core Microfiber with Vernier Effect

Simultaneous Measurement For Liquid Level And Refractive Index Based On All-Fiber Modal Interferometer