Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Bond behavior between steel bars and 3D printed concrete: Effect of concrete rheological property, steel bar diameter and paste coating

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Experimental Investigation on Influence of Embedment Length, Bar Diameter and Concrete Cover on Bond Between Reinforced Bars and Steel Fiber Reinforced Concrete (SFRC)

Bond Performance Between BFRP Bars and 3D Printed Concrete

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Study of Bond Behavior between Concrete and Steel Bars Based on New Beam Specimens

Bonding properties between 3D printed coarse aggregate concrete and rebar based on interface structural characteristics

Bonding performance of 3D printing concrete with self-locking interfaces exposed to compression–shear and compression–splitting stresses

3D-printed concrete permanent formwork: effect of postcast concrete proportion on interface bonding

Research on the Preparation and Mechanical Properties of Solidified 3D Printed Concrete Materials

3D printing concrete with recycled coarse aggregates: The influence of pore structure on interlayer adhesion

Triaxial compressive behavior of 3D printed PE fiber-reinforced ultra-high performance concrete

Investigation of steel wire mesh reinforcement method for 3D concrete printing

Interfacial bonding properties of 3D printed permanent formwork with the post-casted concrete

Strength and Proportioning Design of 3D Printed Concrete (3DPC) Based on Aggregate Gradation Optimization

Mechanical and macrostructural properties of 3D printed concrete dosed with steel fibers under different loading direction

Research on the Bonding Performance of BFRP Bars with Reactive Powder Concrete

Study on the mechanical properties of 3D printing concrete layers and the mechanism of influence of printing parameters

Bond-Slip Behavior of Steel Bar and Recycled Steel Fibre-Reinforced Concrete

Trans-layer and inter-layer fracture behavior of extrusion-based 3D printed concrete under three-point bending

The Effect of Fiber on the Green Strength and Buildability of High-Strength 3D Printing Concrete