Abstract:Solid-state transformers (SST) are emerging technologies to replace the conventional low-frequency main transformer (MTR) in railway vehicles. In order to isolate the load side from the AC 25 kV high-voltage (HV) side and to reduce the whole size of the SST, HV insulation and high-frequency transformers should be used in DC/DC converters. Furthermore, due to the severe constraint of installation space and difficulty of heat dissipation management in the bottom of railway vehicles, high-power density and minimum transformer loss should be considered. To satisfy such design requirements of the proposed SST for railway vehicles, high efficiency integrated transformers, which inherently have leakage inductance, are proposed for dual-active-bridge (DAB) converters in this paper. In order to obtain appropriate equivalent leakage inductance for the DAB converters, a calculation methodology for the leakage inductance has been introduced and verified by simulation. Two separated winding structures in the center-core are adopted to improve the core loss, and appropriate winding turns with 60 kV HV insulation capability are selected, according to the proposed design procedure of the integrated transformers. In order to compare the proposed transformers with the conventional transformer having additional inductors and to verify the major characteristics of the transformers, two 125 kW proposed transformers and conventional transformers have been built and evaluated by an 250 kW SST module, operating at 10 kHz switching frequency. Under a 125 kW full-load condition, 99.7% transformer efficiency was obtained by the proposed integrated transformers, which are 4.7% smaller and 7.0% lighter than the conventional transformer. As a result, 26°C maximum temperature improvement has been obtained and 60k V HV insulation capability has been satisfied by the proposed integrated transformers.

Common-mode Electromagnetic Interference Mitigation for Solid-state Transformers

A Soft-Switching Solid-State Transformer Module

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

Accelerated Electromagnetic Transient (EMT) Equivalent Model of Solid-State Transformer

Bilateral Common-mode Voltage Injection Method with Minimized Low-frequency Ripple Buffering of AC/AC Solid-State Transformer

Modeling and Design of a Medium Frequency Transformer with High Isolation and High Power-Density

Synergetic Control of High-Frequency-Link Based Multi-Port Solid State Transformer

Research on Triple-Port SST Scheme Based on the Natural Elimination of MMC Sub-Modules Voltage Fluctuation and Imbalance

Design and Implementation of High Efficiency Control Scheme of Dual Active Bridge Based 10 Kv/1 MW Solid State Transformer for PV Application

Active Thermal Control for Cascaded H-Bridges in Solid State Transformers

Common High-Frequency Bus Based Cascaded Multilevel Solid-State Transformer With Ripple and Unbalance Power Decoupling Channel

Arm integrated double capacitor submodule for modular multilevel solid-state transformers with DC short-circuit fault ride-through capability

Efficiency Improvement of Solid-State Transformers with MMC Front-End AC-DC Converters Through Adjusting DC Bus Voltage and Active Cells

Power synchronization control for capacitor minimization in Solid State Transformers (SST)

Efficiency Enhancement of DC Solid-State Transformers by Dynamically Adjusting Active Cells

500kva Hybrid Solid State Transformer (Hsst): Architecture, Functionality And Control

Voltage and Power Balance Control for a Cascaded H-Bridge Converter-Based Solid-State Transformer

Design and Control of Power Fluctuation Delivery for Cell Capacitance Optimization in Multiport Modular Solid-State Transformers

High Efficiency Integrated Transformer Design in DAB Converters for Solid-State Transformers

Research on Asymmetrical Operation of Multilevel Converter-Type Solid-State Transformers Based on High-Frequency Link Interconnection