Effect of initial turbulence on explosion behavior of stoichiometric methane-ethylene-air mixtures in confined space
Kai Wang,Mingqing Su,Lijun Wei,Sining Chen,Xiangbei Kong,Yunlong Fang
DOI: https://doi.org/10.1016/j.psep.2022.03.072
IF: 7.8
2022-05-01
Process Safety and Environmental Protection
Abstract:The turbulent explosion process of stoichiometric CH4/C2H4/air mixtures was experimentally studied by using a standard 20 L sphere explosion system and it's powder storage tank as the turbulence generator. Taking the initial turbulent environment and ethylene volume fraction as variables, the effects of turbulence intensity and fuel composition on explosion characteristics were studied. The results show that both turbulence intensity and ethylene content promote the explosion of the mixtures and increase the severity of the explosion, but the influence of turbulence intensity on combustion evolution mainly focuses on heat loss, while the influence of ethylene content mainly focuses on adiabatic explosion. When the ethylene ratios increase to 0.5 or more, the increase of explosion severity caused by turbulence is not obvious. The analysis of experimental results and numerical simulation shows that the influence of initial turbulence generated by powder storage tank on explosion is the result of the combined action of turbulent kinetic energy and combustible gas redistribution.In this paper, the gas products from pyrolysis of tire rubber was respectively studied by fixed bed pyrolysis experiments—gas chromatography analysis and molecular dynamics simulations. The results of experiments showed that the main gas products of pyrolysis were CH4, H2, and C2H4. The simulation results showed that the long rubber chain broke into four main rubber monomers at low temperature: isoprene, styrene, 1,3-butadiene and uncondensated C4H6·. And at higher temperature, the generated monomers were pyrolyzed into small molecule gases. Fe2O3 reduced the final pyrolysis temperature and increased the pyrolysis rate with a good catalytic reactively. And it changed the gas products distribution, in which the proportion of CH4 and H2 were promoted while the proportion of C2H4 was reduced. In order to obtain the thermodynamic and kinetic data of each reaction path, DFT calculation was carried out. The reaction paths of three major radicals H·, CH3·, and CH2 = CH· were further discussed. The results showed that Fe2O3(commercial) promoted the release of CH3· from isoprene monomer and CH3· attack on isoprene monomer and 1,3-butadiene to produce CH4. Moreover, Fe2O3 promoted H· attacking styrene monomer to generate H2.The fluidic jet turbulator has been a novel perturbation generator in the pulse-detonation engines research field for the past few years. In this paper, an experiment is performed to study the deflagration to detonation transition (DDT) process in a detonation chamber with a reactive transverse methane–oxygen mixture jet in crossflow (JICF). The jet injection arrangement is fundamentally investigated, including single jet and various double jets patterns. Corresponding two-dimensional direct numerical simulations with a multistep chemical kinetics mechanism are employed for analyzing details in the flow field, and the interaction between the vortex and flame temporal evolution is characterized. Both the experiments and simulations demonstrate that the JICF can distinctly accelerate flame propagation and shorten the DDT time and distance. The vortex stream induced by the jet distorts and wrinkles the flame front resulting in local flame acceleration. Moreover, the double jet patterns enhance flame acceleration more than the single jet injection because of the intrinsic counter-rotating vortex pairs and enhanced turbulence intensity.Detonation is an energetic combustion mode augmenting high flow momentum and thermodynamic efficiency, it has been applied in detonation engines, such as pulse detonation engines (PDEs) and rotating detonation engines (RDEs), they have become potential aerospace propulsion equipment. Recently, fluidic jet-in-cross flow (JICF) has been demonstrated experimentally and numerically that can accelerate the deflagration-to-detonation transition (DDT) process. Nonetheless, most of previous studies focused on the jets using combustible mixture or oxygen, which may bring additional risk for turbulence-generated system in detonation engines. In this study, a more safe and controllable inert gas (i.e., Ar) is applied for JICF, experiments are carried out to investigate effects of argon jet as an enhancement method on promoting the DDT in a stoichiometric methane-oxygen mixture. The effects of local argon concentration, turbulence intensity and injection position on the DDT process are systematically examined. Two-dimensional numerical simulations are also performed to elucidate the details of the injection evolution. The experi -Abstract Truncated-
engineering, environmental, chemical