Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. The efficiency and working performance of the motor and controller system in micro-electric vehicles depends mainly on its thermal performance, which is contingent upon effective and active cooling. The working temperature of the motor and controller may be too high during operation, which properly causes motor power reduction or motor breakdowns. Therefore, it is crucial to design a good cooling channel for better cooling the integrated motor and controller system. This work proposes an integrated cooling channel of motor and controller, and the fluid-solid coupling analysis is applied for analyzing the velocity, pressure distributions of the cooling channel, and temperature distributions of motor solid components. Meanwhile, the collaborative optimization method based on the multi-island genetic algorithm (MIGA) is used to attain optimal design parameters of the integrated cooling channel of the motor and controller for obtaining a better cooling channel design with lower flow resistance and lower winding temperatures. Results show that the original cooling channel's flow resistance and maximum winding temperature are 31.87 kPa and 120.04°C, respectively. The flow resistance and winding temperature are pretty significant. After optimization, the local vortex flow and zero velocity area in optimal cooling channel design are improved, the coolant flow velocity becomes more uniform, and the flow resistance is significantly reduced. The flow resistance and maximum winding temperature of the optimal cooling channel design are 12.5 kPa and 116.76°C, respectively, which are decreased compared with the original cooling channel structure, with a decrease of 39.4% and 2.7%, respectively. The research findings in this work can provide theoretical reference for solid components temperature evaluation of motor and give valuable data to cooling performance evaluation and optimization of integrated cooling channel for motor and controller system.

Analytical Optimization of the Bearing Voltage of Motor Considering the Thickness of Insulating Coating: an Improved Equivalent Circuit Model

Improved Analytical Modeling of a Novel Ironless Linear Synchronous Machine With Asymmetrical Double-Layer Winding Topology

Multi-Structural Optimization of Bearingless Permanent Magnet Slice Motor Based on Virtual Prototype in Ansoft Maxwell

Investigation of Analytical Models for Surface-Mounted Permanent Magnet Motor Using Voltage Source Inverter

Modeling and Optimization for Submersible Pump Tubular Linear Motor Based on Dynamic Load Analysis

Modeling and Optimal Design of the Rotary-Linear Type Two-Degree-of-Freedom Ultrasonic Motors

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Collaborative optimization on cooling channel flow resistance and winding temperature for integrated cooling of motor and controller

Bi-level optimization and integrated multiple-criteria decision making under uncertainty for structural design of insulated bearings

The influence of optimizing rotor on the performance and the iron loss of the permanent machine

Optimization of the Cooling Channels in A Journal Bearing Based on Thermohydrodynamic Analysis

Optimization for Short-Circuit Fault-Tolerant Mathematical Model of Bearingless Switched Reluctance Motor

DESIGN OPTIMIZATION OF MOTORIZED SPINDLE BEARING LOCATIONS BASED ON DYNAMIC MODEL AND GENETIC ALGORITHM

An Improved Dynamic Modelling for Exploring Ball Bearing Vibrations from Time-varying Oil Film

Analytical Calculation Method of Motor Natural Frequencies Based on Equivalent Model of Three-Layer Cylindrical Shell

Optimization of Voice Coil Motor to Enhance Dynamic Response Based on an Improved Magnetic Equivalent Circuit Model

Accurate Equivalent Modeling and Thermal Analtsis of Stator Slot of Flat Wire Motor

Optimization and Experimental Validation of Amorphous Alloy High-Speed Asynchronous Motor for Simultaneous Reduction on Core and Copper Losses

Modelling and improvement of thermal cycling in power electronics for motor drive applications

Improved thermal model of forced air-cooled motors considering heat transfer in wire-wound winding and end region

Optimization of an induction motor for loss reduction considering manufacturing tolerances