Abstract:Huge and critical structures, such as fuel storage tanks and nuclear power plants, are often built on dense sandy grounds, which may cause excessive plastic deformations under multidirectional cyclic shearing conditions caused by earthquakes. The lack of investigation of sand behavior under multidirectional loading may lead to unsafe designs, and thus significantly increase the maintenance cost for infrastructures during their long operational time, which might be longer than 100 years. This study presents a numerical investigation on the liquefaction behavior of dense sand under bidirectional cyclic simple shear using the discrete element method. The bidirectional cyclic simple shear tests with varying stress trajectories on the deviatoric stress plane, including figure-8, circular, and straight lines, were conducted. Additionally, a series of unidirectional loading tests was conducted in the simulation scheme for comparison purposes. The effect of the initial static shear on the cyclic behavior and liquefaction resistance of granular materials was examined. Four loading categories, including full reversal, partial reversal, intermediate reversal, and no reversal, were implemented in the numerical simulations. Although the presence of the initial static shear may enhance the cyclic resistance of granular samples under unidirectional loading, it mitigates the liquefaction resistance and promotes the failure of specimens under bidirectional shearing conditions. The microscopic analysis was performed to reveal the relationship between the fabric evolution and external loading, which can provide profound insights into the underlying mechanism of the cyclic behavior and liquefaction susceptibility of granular material when both the bidirectional shearing and initial static shear effects are considered.

Mobilization Mechanism and Calculation Method of Embedded Chain Axial Resistance in Sand

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Axial Interaction Between Anchor Chain and Sand. Part II: Cyclic Loading Test

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Relationship between chain axial resistance and confining stress for South China Sea carbonate sand: an element test

Three-dimensional Interaction Between Anchor Chain and Seabed

Cyclic accumulative deformation of sand and its explicit model

Experimental Study on the Sandy Seabed Trench Development of the Catenary Mooring Chain at Touchdown Zone

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Numerical investigations of the effect of strain softening on the behaviour of embedded mooring chains

Prediction of the whole mooring chain reaction to cyclic motion of a fairlead

Soil Deformation and Erosion Near Mooring Chains in Clay Based on Cyclic T-Bar Tests

Experimental Investigation of a Taut Mooring Line Accounting for the Chain–sand Interaction at Model Scale

Micromechanics-based multimechanism bounding surface model for sands

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Assessment of Seabed Trench Formation Based on Marine Sediment Properties and Chain-Bar Penetration Tests

INFLUENCE OF ANCHORAGE DEPTH ON MECHANICAL BEHAVIOUR OF DOUBLE-ROW ANTI-SLIDE PILES