Abstract:Field observations of semitaut mooring systems have shown severe trench development in front of suction caissons. Trenches extend back from where the chain emerges from the seabed under ambient mooring loads to relatively close to the caisson and with depths approaching the padeye depth. To help understand the process, a coupled Eulerian–Lagrangian (CEL) approach has been used to apply cyclic loading to a mooring chain system, treating the chain as a series of linked cylindrical elements and the soil as a strain-softening Tresca material. The chain extended through the soil into the water column, and cyclically changing boundary conditions were applied to the far end of the chain to reflect a typical mooring layout and metocean conditions. Despite rather idealized conditions, with loading restricted to the vertical plane of the chain and no consideration of hydrodynamic effects, a stable trench profile developed after only a few cycles of loading. The chain profile straightened during the cycles, with the section nearest to the padeye gradually cutting deeper into the soil and with the amplitude of cyclic motions of the chain, and hence tendency for a trench to form, increasing at shallower depths. The magnitude of soil resistance acting on the chain reduced by increasing cycles, with particularly low resistance in the zone where the trench was most developed. The long-term longitudinal profile of trenching was predicted based on the current modeling and was found comparable to that inferred from field observations, even without consideration of hydrodynamic and out-of-plane effects.

Experimental Study on the Sandy Seabed Trench Development of the Catenary Mooring Chain at Touchdown Zone

Soil Deformation and Erosion Near Mooring Chains in Clay Based on Cyclic T-Bar Tests

Seabed Trenching Near the Mooring Anchor: History Cases and Numerical Studies

IMPROVED EMPIRICAL FORMULATION FOR SEABED TRENCH PROFILE AT TOUCHDOWN ZONE AND ITS EFFECTS ON FATIGUE OF STEEL CATENARY RISERS

Numerical Investigations into Development of Seabed Trenching in Semitaut Moorings

Prediction of the whole mooring chain reaction to cyclic motion of a fairlead

Experimental Investigation on Responses Characteristics of a Mooring Line with Imposed Top-End Motions

Numerical modelling on effect of loading rate on uplift behavior of suction caissons

Numerical Prediction of Potential 3-Dimensional Seabed Trench Profiles Considering Complex Motions of Mooring Line

Assessment of Seabed Trench Formation Based on Marine Sediment Properties and Chain-Bar Penetration Tests

Review on Seabed Trenches Induced by Mooring Lines and Analyses of Anchor Bearing Capacity

Experimental Study on Lateral Behaviour of Tetrapod Caisson Foundations in Silt

Experimental Study on Lateral Pile–soil Interaction of Offshore Tetrapod Piled Jacket Foundations in Sand

Three-dimensional Interaction Between Anchor Chain and Seabed

Axial Interaction Between Anchor Chain and Sand. Part II: Cyclic Loading Test

Mooring Analysis of Trencher Engineering Ship Based on MOSES Software

A case study on the seabed trenching assessment and anchor design in clay based on the hydrodynamic calculation of the floater

A Framework for Mooring and Anchor Design in Sand Considering Seabed Trenches Based on Floater Hydrodynamics

Lateral Cyclic Interaction Between Catenary Riser and Soft Seabed

Interaction between catenary riser and soft seabed: Large-scale indoor tests

Quasi-static Three-Dimensional Analysis of Suction Anchor Mooring System