Abstract:The software-assisted reliability assessment of power electronic converters is increasingly important due to its multi-domain nature and extensive parametric calculations. The rainflow counting algorithm is gaining popularity for its low relative error in device lifetime estimation. Nevertheless, the offline operation of the algorithm prevents most simulation software packages considering other parameters for the device under study, such as aging and the current state of health in the estimation, as it requires a complete loading profile to run recursive comparison. This also brings difficulties in realization in circuit simulators such as SPICE. To tackle the issue, an in-the-loop circuit-based rainflow counting algorithm is proposed in this paper, and applied to estimate the consumed lifetime of the MOSFET in a boost converter for illustration. Instantaneous electrical and thermal performances, and the accumulated stress of the device can be monitored. Not only does this assist in evaluating the state of health of a device, but also allows the possibility of integrating the aging into the lifetime evaluation. The method follows the four-point rainflow counting algorithms, which continuously compares three adjacent temperature fluctuations ΔTj to select full cycles for two rounds, and the remaining cycles are counted as half cycles. To validate the performance, a comparative analysis in terms of counting accuracy and simulation speed was performed alongside the proposed method, MATLAB® and also with a well-accepted half-cycle counting method. Reported results show that the proposed method has an improved counting accuracy compared to the half-cycle counting from 24% to 3.5% on average under different load stresses and length conditions. The accuracy can be effectively improved by a further 1.3–2% by adding an extra comparison round.

A Fast Method to Estimate Through-Bump Current for Power Delivery Verification

High-Frequency Electrothermal Characterization of TSV-Based Power Delivery Network

A Silicon-Validated Methodology for Power Delivery Modeling and Simulation

A Simplification Method for Power Device Thermal Modeling with Quantitative Error Analysis

Silicon-Validated Power Delivery Modeling and Analysis on a 32-Nm DDR I/O Interface.

Worst-case Power Integrity Prediction Using Convolutional Neural Network.

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

Design Time Body Bias Selection for Parametric Yield Improvement.

Failure Mechanism and Predictive Modeling for Microbump Interconnects Drop Life Under Diverse Impact Angles in Advanced Packaging

Fast voltage drop modeling of power grid with application to silicon interposer analysis

Electromagnetic Shielding Analysis of Different Grounded Bump Distribution in SiP

A Two-Port Measurement With Mechanically Robust Handhold Probes for Ultra Low PDN Impedance

An improved method for test chip design

Fast transient simulation algorithm for a 3D power distribution bus

Circuit-Based Rainflow Counting Algorithm in Application of Power Device Lifetime Estimation

Thermal-Aware Small-Delay Defect Testing in Integrated Circuits for Mitigating Overkill

Mechanical and Electrical Reliability Assessment of Bump-Less Wafer-on-wafer Integration with One-Time Bottom-Up TSV Filling

Efficient Power Grid Integrity Analysis Using On-the-fly Error Check and Reduction

A Method for Automatically Predicting the Radiation-Induced Vulnerability of Unit Integrated Circuits

A Leakage Power Estimation Method for Standard Cell Based Design