Performance Study of Cement-Based Grouts Based on Testing and Thermal Conductivity Modeling for Ground-Source Heat Pumps

Shihao Dong,Guang Liu,Tao Zhan,Yang Yao,Long Ni

DOI: https://doi.org/10.1016/j.enbuild.2022.112351

IF: 7.201

2022-01-01

Energy and Buildings

Abstract:The annulus zone between the vertical ground heat exchanger and borehole wall needs to be filled with grout to enhance heat exchange and prevent groundwater pollution. However, studies on porosity, the dual influence of water-to-cement and sand-to-cement ratios on material properties and theoretical studies need to be deepened. Hence, the flowability, thermal conductivity, and porosity of cement -based grouts with various proportions were tested. It was found that the increase in the sand-to -cement ratio and decrease in the water-to-cement ratio helps in the augmentation of thermal conductiv-ity and decrease of porosity, but lowers the flowability. When the water-to-cement ratio is 0.55, a sand -to-cement ratio higher than 2.0 will lead to excessive fissures and thus weaken the thermal conductivity. The maximum thermal conductivity reaches 2.10 W.m(-1).K-1 in the saturated state with a porosity of 0.2442. A high porosity indicates a larger permeability and poor thermal performance; therefore, the sug-gested porosity is below 0.43. Moreover, the thermal conductivity-change mechanism was studied by the series-parallel thermal conductivity model, which can predict the thermal conductivity with an error of less than 10 %. The model shows that the heat conduction of the components in the grout is mainly in series. Additionally, improving the sand-to-cement ratio, maintaining high saturation, reducing the porosity, and adding high-performance aggregates are all ways to improve the thermal conductivity of the material. And the grouts-taking value area is also marked out. (C) 2022 Elsevier B.V. All rights reserved.