Manipulate the magnetic properties of AlNiCo films by tuning non-magnetic phase structures
Xinyan Yang,Xiulan Xu,Guonan Feng,Jintao Liu,Di Zhao,Wenxiang Ai,Zhihao Gai,Chuyue Liu,Guanghua Yu
DOI: https://doi.org/10.1016/j.apsusc.2023.157584
IF: 6.7
2023-05-24
Applied Surface Science
Abstract:AlNiCo films have very promising applications in magnetic encoders. However, the films must have sufficient coercivity and remanence for practical applications. We prepared AlNiCo (50 nm)/X(t) (X: Ta or Ti, t=0-9 nm) films using magnetron sputtering followed by vacuum annealing at 750 °C for 30 min. Compared with AlNiCo (50 nm) film (Hc=79 Oe, Mr=10130 Oe), the coercivity (Hc=289 Oe) of AlNiCo (50 nm)/Ti (7 nm) is increased by 266 %, and the remanence is 10005 Oe. Especially, the coercivity (Hc=663 Oe) of AlNiCo(50 nm)/Ta (7 nm) is improved by 739 %, but the remanence is 3671 Oe, meeting the performance requirements of magnetic code disks. The microstructure analysis demonstrates that the diffusion of Ta and Ti atoms during annealing leads to the formation of diffusely distributed non-magnetic phases (Fe 2 Ta and Co 2 Ta) and well-crystallized non-magnetic phases (Ni 3 (Al,Ti)) in films. The diffusely distributed non-magnetic phases have stronger pinning effects on the domain walls, which we believe is an important reason for the enhancement of the coercivity. Additionally, the formation of Fe 2 Ta and Co 2 Ta phases leads to the loss of magnetic moments, but Ni 3 (Al,Ti) does not. Therefore, the Mr of AlNiCo/Ta film decreases, while the Mr of AlNiCo/Ti film does not change.
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films