Abstract:High entropy alloy nitride coatings (HEAN), showing superior mechanical strength, high oxidation resistance, and thermal stability, have often been used in protective hard coatings field. However, the high temperature tribological field of novel HEA nitride films has not yet been well studied. The correlations among tribological properties, compressive residual stress, mechanical properties, and self-lubricating oxide are still limited.In this research, the novel (AlCrNbSiTiMo)N coatings were fabricated on both Inconel-718 and Si (100) substrate by radio frequency (RF) magnetron sputtering via tuning both substrate bias at 300 °C deposition temperature. The (AlCrNbSiTiMo)N coatings with a specific substrate bias exhibit an outstanding hardness of 34.5±0.8 GPa.In the wear test at 700 °C, the films deposited at −100 V revealed the lowest wear rate around 1.2 × 10−6 mm3N−1 m−1. With Molybdenum doping, the MoO3 Magnéli phase was observed on the surface at elevated temperature wearing process, and the friction coefficient at high temperature decreased significantly due to a lubricating surface. The coating exhibited the average friction coefficient value of 0.48 in the wear test of 700 °C. The high temperature tribological performance was addressed and related to the mechanical properties, the plastic deformation resistance H3/E2, and the excess residual stress of the films.This study provides a new design for hard coatings applied to severe wearing conditions. By tuning substrate bias, the (AlCrNbSiTiMo)N coatings exhibit outstanding mechanical and tribological characteristics, which will be a promising candidate for high temperature tribological protective film.

Effect of Heat-Treatment Time on Microstructure and Tribological Behavior of (tivcralmo)n High-Entropy Alloy Films

Effect of Carbon and Heat Treatment on the Microstructure and Properties of VAlTiCrSi High-Entropy Alloy Films

Effect of Heat Treatment on Microstructure and Wear Behavior of Laser Clad FeCoCrMoNi High-Entropy Alloy Coatings

High-Temperature Tribological Behavior of Al0.3Cr0.5Fe1.5Mn0.5Ni High-Entropy Alloys With Addition of Titanium and Carbon

Microstructure and Friction Properties of AlCrTiVNbx High-Entropy Alloys via Annealing Manufactured by Vacuum Arc Melting

Microstructural and Tribological Behavior of Thermal Spray CrMnFeCoNi High Entropy Alloy Coatings

Heat treatment effects on microstructure and mechanical properties of TiZrNbTa high-entropy alloy

Microstructural Features, Corrosion and Wear Behavior of the AlCrFeCoNiCu High-Entropy Alloy, Electrodeposited Coatings, and Subsequent Heat Treatment

Investigation of Hardness, Tribological and Adhesion Properties of TiAlNiVN HEA Films Heat Treated at Different Temperatures

Microstructure and Wear Behavior of AlCrTiNbMo High-Entropy Alloy Coating Prepared by Electron Beam Cladding on Ti600 Substrate

Microstructures and Tribological Properties of TiC Reinforced FeCoNiCuAl High-Entropy Alloy at Normal and Elevated Temperature

Mechanical Properties and Tribological Behavior of Al0.5CoCrFeNb0.5Ni High-Entropy Alloy at High Temperatures

Effect Of Ti Addition On The Microstructure And Wear Properties Of Alfecrcocu High-Entropy Alloy

Microstructure and Tribological Performance of Ultra-High Speed Laser-Cladded AlCrCoFeNi2.1-xTiB2 (x = 0, 0.5, 1.0, 1.5 and 2.0 Wt%) High-Entropy Alloy Coatings

Effect of Heat Treatment on the Microstructure and Mechanical Properties of the Al0.6CoCrFeNi High-Entropy Alloy

Effect of Heat Treatment on the Microstructure and Mechanical Properties of TiAl Alloys

High-temperature oxidation behaviors and mechanical properties of TiAlCrMnHEAs during heat treatment

Effect of different durations on the microstructure and tribological behavior of (Co1.5FeNi)90Ti6Al4 high entropy alloy

Improvement of high entropy alloy nitride coatings (AlCrNbSiTiMo)N on mechanical and high temperature tribological properties by tuning substrate bias

Cultivating a Comprehensive Understanding of Microstructural Attributes and Wear Mechanisms in FeCrCoNiAlTi x High-Entropy Alloy Coatings on TC6 Substrates Through Laser Cladding Fabrication

Microstructure and sliding wear behavior of HVOF sprayed Al(1−x)CoCrFeNiTix high-entropy alloy coatings