Abstract:In pulverized solid fuel combustion, radiation is the primary heat transfer mechanism. Especially in the near-burner region with high particle loadings, particle radiation dominates gas radiation. Thus, adequate modeling of particle-radiation interactions in full-scale simulations of combustion chambers may primarily affect the overall accuracy. The radiation behavior depends strongly on the particles? optical properties, characterized by the complex index of refraction (IOR). The IOR depends on particle morphology and material composition which change during pyrolysis and char conversion. For char conversion, the focus of the present paper, the change depends on how the structural transformations take place inside the particle, characterizes by the reaction regimes, boundary layer diffusion limited, pore diffusion limited or kinetically controlled. The formation of an outer ash film layer with progressing burnout can complicate the situation even more. To quantify the effects of the structural changes during the char conversion process on the radiative properties, the output data of the char conversion kinetics (CCK) model (particle size, ash/carbon content, pore fraction) are used to build artificial particles at different conversion degrees and for the different regimes. Finally, the radiation interaction is calculated by applying an extension of the Mie theory for coated particles, and these results are compared to simplified approaches. Simplified approaches were tested to derive the IOR by applying mixing rules based on the available char and ash content with progressing char conversion. The results indicate that only a non-linear mixing rule for the IORs of ash and char lead to appropriate approximations of the radiation behavior of the particle. Furthermore, it is not necessary to model the spatial arrangement of carbon core and ash film for the radiative properties. Modeling a sphere and calculating an effective IOR depending on the carbon, ash, and pore volume fraction results in an average deviation of less than 3 % to the exact solution.

Radiative heat transfer in splash and dilution zones of the pressurized oxy-fuel combustion CFB considering particle-dependent scattering

Measurements and Modelling of Oxy-Fuel Coal Combustion

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Hydrodynamics and Heat Transfer in a Fluidized Bed with Liquid Spray: Particle Color-Change Based Measurement and Modelling

Modelling the Combustion of Thermally Thick Biomass Particles

Theoretically Studies of the Coal Particle Cluster Combustion Behavior in a Circulating Fluidized Bed

Coupling radiative properties with detailed char conversion kinetics

DEM–CFD Simulation of the Particle Dispersion in a Gas–solid Two-Phase Flow for a Fuel-Rich/lean Burner

Particle-Scale Investigation of Heat Transfer and Erosion Characteristics in a Three-Dimensional Circulating Fluidized Bed

New Weighted-Sum-of-gray-gases Model for Typical Pressurized Oxy-Fuel Conditions

Particle-Scale Investigation of Thermal Radiation in Nuclear Packed Pebble Beds

Pulverized Coal Combustion in Boundary Layer Turbulence Using Direct Numerical Simulation

Numerical Investigation of Gas-Particle Flow in the Primary Air Pipe of a Low NOx Swirl Burner – the DEM-CFD Method

Research on the particle scale gas and solid non-gray thermal radiation transfer

Numerical Simulation of Low Calorific Gas Combustion and Heat Transfer in Porous Media

CFD-DEM investigation of flow and heat transfer characteristics in a directly irradiated fluidized bed

Numerical Simulation on the Rich/Lean Pulverized Coal Burner

MP-PIC Simulation on Solid Dispersion in a 350 MW CFB Boiler

Modeling Research On Char Particle Combustion Behavior In Cfb Condition

CFD-DEM Simulation of Heat Transfer in Fluidized Beds: Model Verification, Validation, and Application

Kinetic Simulation Of Fine Particulate Matter Evolution And Deposition In A 25 Kw Pulverized Coal Combustor