Abstract:Anisotropic thermal transport plays a key role in both theoretical study and engineering practice of heat transfer, but accurately measuring anisotropic thermal conductivity remains a significant challenge. To address this issue, we propose the three-sensor 2ω method in this study, which is capable of accurately measuring the isotropic or anisotropic thermal conductivity of solid materials. In this method, several three-sensor groups following the design guidelines are fabricated upon the sample along different characteristic directions, and each group consists of three parallel metal sensors with unequal widths and distances optimally designed based on sensitivity analysis. Among the three sensors, the outer two serve as AC heaters and the middle one as a DC detector. The 2ω voltage signals across the detector in each three-sensor group are measured, and then the data are processed by the proposed Intersection Method to derive thermal conductivities along directions of interest. The application of the detector's 2ω instead of the heater's 3ω voltage signals eliminates errors introduced by the uncertainties of thermal resistance in superficial structures (metal layer, insulation layer, interface, etc.). Meanwhile, by replacing the fitting algorithm with the Intersection Method, the local optimum trap of multivariate fitting is avoided. To verify the accuracy and reliability, four typical monocrystalline semiconductors, i.e., Si, GaN, AlN, and β -Ga 2 O 3 , are measured, and the results are consistent with the literature. This method will provide a comprehensive and versatile solution for the thermal conductivity measurements of solid materials.

Measurement of Anisotropic Material by Using Orthomode Transducer for High Efficiency

High-Order Mode-Matching-Based Single-Cavity Coaxial Transducer for Broadband Measurement of Complex Permittivity

Multiband Permittivity Measurement Using Directional Coupler Based on Groove–Ridge-Gap Waveguide

Anisotropic Permittivity Measurement Using a Strip Air Line System

Retrieving Material Permittivity Under Oblique Incidence

Broad-Band Orthomode Transducers

An Improved NRW Method for Thin Material Characterization Using Dielectric Filled Waveguide and Numerical Compensation

Anisotropic complex permittivity measurement using a microstrip air line

Far-field Characterization of Material Permittivity Based on Nonlinear Inversions

A Systematic Material Characterization Method via Near-Field Scanning Microwave Microscopy

Noncontact measurement of complex permittivity based on the principle of mid-range wireless power transfer

A More Accurate Measurement Method of the Dielectric Material Properties With High Tolerance Using an Overmoded Waveguide

An X-band waveguide measurement technique for the accurate characterization of materials with low dielectric loss permittivity

Three-sensor 2ω method with multi-directional layout: A general methodology for measuring thermal conductivity of solid materials

Noncontact Measurement of Complex Permittivity of Electrically Small Samples at Microwave Frequencies

Non-contact measurement of complex permittivity based on coupled magnetic and electric resonances

Challenges of Measuring the Complex Permittivity and Permeability of Thin Materials in Millimeter Wave Regimes (140Ghz–220ghz)

A Novel Permittivity Measurement Method Using Multiple TM mn0 Modes of Cylindrical Cavity

A Dual-Band Resonator Sensor for Low Permittivity Characterization

Optimization of Asymmetric Orthomode Transducer at Terahertz Frequency