Abstract:Vortex-induced motion (VIM) of an offshore platform with multi-columns is an area of sig-nificant focus in the field ocean engineering. VIM involves the complex fluid-structure interaction problem. In this paper, the Reynolds-averaged Navier-Stokes solver combined with the shear-stress transport k-ω turbulence model for the Navier-Stokes equations was used to simulate the VIM of multi-columns with low mass ratio for different flow-approaching angles and reduced velocities. The values of natural period and dimensionless damping coefficient for columns were taken from the model test in the State Key Laboratory of Ocean Engineering of Shanghai Jiaotong University. A com-putational grid was set up using GAMBIT software. The coupling fluid-structure interaction between the columns and the flow field was obtained by calculating the instantaneous lift and drag forces acting on the multi-columns caused by the external flow field. The differential motion equation was solved by fourth-order Runge-Kutta method, which was manually written into the user-defined func-tions, and dynamic mesh technology was then adopted to update flow field. The maximum and nomi-nal statistics methods were used to analyze the amplitude of VIM. When the reduced velocities were small, the ‘jump’ phenomenon was observed in the amplitude curve for 0° flow-approaching angle regardless of whether motion in the stream-wise direction was limited. The maximum amplitude was 0.5D when motion in the stream-wise direction was not limited and was slightly smaller than the maxi-mum amplitude of the limited motion in the stream-wise direction 0.57D). The restriction of motion in the stream-wise direction and the selection of statistical method significantly affected the size of the ‘lock-in’ region. Galloping at the low-frequency and multiple-frequency lock in phenomena was observed for the flow-approaching angles of 0° and 45°. Variation trends of equilibrium position with reduced velocity were very close for the three typical flow-approaching angles. When the re-duced velocity was greater than 6.0, the maximum stream-wise amplitude heading was 22.5°, where-as the minimum stream-wise amplitude heading was 0° heading. The vortex shedding pattern of mul-ti-columns showed the 2P mode.

PIV Measurements on Flow Behavior Behind a Mooring Line with Imposed Top-End Motion

Experimental Investigation on Responses Characteristics of a Mooring Line with Imposed Top-End Motions

Experimental and Numerical Investigations of Film Flow Behaviors in Resonance Section over Corrugated Plates

Model test study on vortex-induced motions of a floating cylinder

Experimental Study on the Sandy Seabed Trench Development of the Catenary Mooring Chain at Touchdown Zone

3-D Flow Measurements Of A Swirling Jet Induced By A Propeller By Using Piv

Experimental studies on the effects of draft condition, current heading and mooring stiffness on vortex-induced motions of a Tension-Leg Platform

Experimental and numerical investigations into flow features in an intake duct for the waterjet propulsion under mooring conditions

Influence of heave motion on the damping force of a mooring line

Laboratory study on movement characteristics of a river plume using particle image velocimetry

Investigation of the Flow Field of a Ship in Planar Motion Mechanism Tests by the Vortex Identification Method

Experimental study on vortex-induced motions of a semi-submersible with square columns and pontoons at different draft conditions and current incidences

Experimental and Numerical Study on Vortex-Induced 1 Motions of a Deep-Draft Semi-Submersible 2

Stereo Particle Image Velocimetry Measurements of the Wake Fields Behind A Panamax Bulker Ship Model under the Ballast Condition

Motion and Dynamic Responses of a Semisubmersible in Freak Waves

Development of a numerical mooring line model for a floating wind turbine based on the vector form intrinsic finite element method

Research on the Effects of In-Line Oscillatory Flow on the Vortex-Induced Motions of A Deep Draft Semi-Submersible in Currents

Experimental study on motion response of a submersible spherical model under the action of internal solitary wave propagating over a ridge topography

Research on vortex induced motion of a deep draft semisubmersible with four rectangular columns

Effect of bathymetry irregularities on the energy dissipation of a mooring line

Study of Vortex Induced Characteristics of Multi-columns with Low Mass Ratio