Abstract:An experimental study on the aerobreakup of a wall-attached droplet induced by a shock wave is carried out in this work. The shock wave and the post-wave air stream are generated by a shock tube facility, and the dynamics of droplet breakup are captured through high-speed imaging from the side, the oblique front and the back views, respectively. The wall-attached droplets with different wettabilities are considered, including the hydrophobic, hemispherical and hydrophilic ones. For the convenience of analysis, droplets with different wettabilities are unified with the same equivalent radius and, thus, the same Weber number and Reynolds number. Different from the evolution of a free spherical droplet, it is observed that the hydrophobic droplet can develop ‘peak’ structures on the windward and leeward sides, respectively; while the hemispherical and hydrophilic droplets leave a liquid film on the wall. The occurrence of ‘peak’ structures is caused by the local standing vortex on the droplet windward and leeward sides, and the residual of a liquid film on a solid wall is related to the boundary layer near the wall. Through comparing the height, width and advancing distance of droplet deformation between the spherical droplet and the wall-attached droplets with different wettabilities, it is found that the wall will inhibit the deformation and fragmentation of droplets on the flow direction. The ‘peak’ and film structures are responsible for the deviation of the dimensionless width between spherical and wall-attached droplets. The ‘lip’ structure is related to the recirculation flow at the rear of the droplet, which causes the reverse of velocity on the surface. The radius of the ‘lip’ decreases with the decrease of contact angle. The Rayleigh–Taylor (R–T) and Kelvin–Helmholtz (K–H) instabilities of wall-attached and spherical droplets are also studied by experiments and theoretical analysis. With the decrease of contact angle, the development of the K–H instability hardly changes, while the R–T instability results in a smaller wavelength of perturbation on the windward side. This study is expected to give some guidance for regulating the aerodynamic fragmentation of droplets in engineering applications.

Numerical Investigations on the Deformation and Breakup of an N-Decane Droplet Induced by a Shock Wave

Effects of Airflow Velocity and Droplet Diameter on the Secondary Breakup Characteristics

Numerical Simulation of the Collision Behaviors of Binary Unequal-Sized Droplets at High Weber Number

Effect of phase change on shock wave and n-dodecane droplet interaction with numerical investigation

Deformation Characteristics of Droplet Generated by Rayleigh Jet Breakup

THE VISCOUS EFFECT ON THE TRANSIENT DROPLET DEFORMATION PROCESS UNDER THE ACTION OF SHOCK WAVE

Experimental Investigation of Breakup Times of Droplet under the Action of Shock Wave

Visualization Research of Droplet Deformation and Breakup in the Multimode Regime

Breakup of a kerosene droplet at high Weber numbers

Secondary Droplet Size Distribution Upon Breakup of a Sub-Milimeter Droplet in High Speed Cross Flow

Viscous Effect on the Droplet Deformation Process under High Weber Number Conditions

Numerical simulation of the aerobreakup of a water droplet

Single and two-phase fluid droplet breakup in impulsively generated high-speed flow

Droplet breakup and rebound during impact on small cylindrical superhydrophobic targets

The interaction between droplets and the vortex ring after a shock wave

Exploration of Shock–droplet Interaction Based on High-Fidelity Simulation and Improved Theoretical Model

Experimental Investigation on the Properties of Liquid Film Breakup Induced by Shock Waves

Two-dimensional Simulation of Drop Deformation and Breakup at Around the Critical Weber Number

On Shock Induced Aerobreakup of a Wall-Attached Droplet

Intense deformation and fragmentation of two droplet collision at high Weber numbers

Numerical Study on Shock / Droplet Interaction Before a