Abstract:Control of low-concentration pollutants from a semiconductor process vent stream using a wet-scrubbing technique is a challenging task to meet Taiwan environmental emission standards. An efficient wet-scrubber is designed on a pilot scale and tested to control low concentration acid and base waste-gas emission. The scrubber system consisted of two columns, i.e., a fine spray column [cutoff diameter (based on volume), Dv(50) = 15.63 microm; Sauter mean diameter (SMD) = 7.62 microm], which is especially efficient for NH3 removal as the pH of the spraying liquid is approximately 7 followed by a packed column with a scrubbing liquid pH approximately 9.0 mainly for acids removal. It is observed that use of the surfactants in low concentration about 10(-4) M and 10(-7) M in the spray liquid and in the scrubbing liquid, respectively, remarkably enhances the removal efficiency of the system. A traditional packed column (without the spray column and the surfactant) showed that the removal efficiencies of NH3, HF, and HCl for the inlet concentration range 0.2 to 3 ppm were (n = 5) 22.6+/-3.4%, 43.4+/-5.5%, and 40.4+/-7.4%, respectively. The overall efficiencies of the proposed system (the spray column and the packed column) in the presence of the surfactant in the spray liquid and in the scrubbing liquid forthese three species were found to increase significantly (n = 5) from 60.3+/-3.6 to 82.8+/-6.8%, 59.1+/-2.7 to 83.4+/-4.2%, and 56.2+/-7.3 to 81.0+/-6.7%, respectively. In this work, development of charge on the gas-liquid interface due to the surfactants has been measured and discussed. It is concluded that the presence of charge on the gas-liquid interface is the responsible factor for enhancement of the removal efficiency (mass-transfer in liquid phase). The effects of the type of surfactants, their chain length, concentration in liquid, etc. on the removal efficiency are discussed. Since the pilot tests were performed under the operating conditions similar to most of the wet-scrubbers operated in semiconductors manufacturing facilities for inorganic pollutants, this study can be applied to modify the existing wet-scrubbers to enhance the removal efficiencies, especially for low-concentration pollutants.

Fast Real-Time Measurement Method of a Wet Scrubber on Particle Purification Efficiency with Image Information Entropy Analysis

A real-time measurement and analysis method for gas holdup in a wet scrubber with the use of image information entropy

Detection of Particle Mass Flowrate in High-Speed Fluidization Based on Acoustic Emission Technology

Online Measurement of Particle Charge Density in A Gas-Solid Bubbling Fluidized Bed Through Electrostatic and Pressure Sensing

Holographic Slurry Droplet Monitor: Design and Its Application to 1000 MW Coal-Fired Power Unit

Portable Digital Holographic Particle Analyzer (DHPA) for Pneumatically Conveyed Fuel Monitoring: Design and Validation

Online Measurement of Wet Gas Mass Flowrate Based on Averaging Pitot Tube-Vortex Integrated Sensor

On-line monitoring of membrane fouling based on an improved electrical measurement method

Integrated method of wavelet packet analysis and K-OPLS and its application in measurement of particle size distribution

Performance Evaluation Of A Three-Stage Composite Wet Scrubber For Removing Particulate Matter

Measurement of Slurry Droplets in Coal-Fired Flue Gas after Wfgd

Numerical Investigation on Urea Particle Removal in a Spray Scrubber Using Particle Capture Theory

Study on a comprehensive evaluation method for the assessment of the operational efficiency of wastewater treatment plants

Real-time Data Processing of Remote Measurement of Air Pollution by Infrared Passive Scanning Imaging System

Efficient control system for low-concentration inorganic gases from a process vent stream: application of surfactants in spray and packed columns

A Method for Measuring the Critical Pore Diameter of a Homogeneous Microchannel Separator Based on Image Analysis and a Simulation Comparison of CFD-DEM

Structured packing improves wet scrubbing of airborne molecular contaminants in cleanroom make-up air units

An energy‐efficiency evaluation method for high‐sulfur natural gas purification system using artificial neural networks and particle swarm optimization

Fluctuation analysis and spatial distribution model of particle concentration in a lab-scale scrubbing-cooling chamber

Two-phase hydrodynamics and aerosol mass transfer characterization in pool scrubbing: A simultaneous measurement technique

A novel method for identifying aerobic granular sludge state using sorting, densification and clarification dynamics during the settling process