Abstract:The Ti-6Al-4V (TC4) alloy wheel hub has exhibited some defects that affect the properties during the vertical centrifugal casting process. Therefore, the analysis of the solidification process would contribute to solving the above-mentioned problems. In this study, an orthogonal experimental design was employed to optimize the process parameters (rotational speed, mold preheating temperature, and pouring temperature) of the vertical centrifugal casting method. The effects of process parameters on the velocity field, temperature field, and total shrinkage porosity during the solidification process were explored, and the microstructure and mechanical properties of the wheel hub prepared by the vertical centrifugal casting method were also investigated. The results showed that the rotational speed mainly induced the change of the velocity field. The pouring temperature and mold preheating temperature affected the temperature field and solidification time. Based on the analysis of the orthogonal experiment, the optimal parameters were confirmed as a rotational speed of 225 rpm, mold preheating temperature of 400 °C, and pouring temperature of 1750 °C, respectively. The simulation results of total shrinkage porosity were in agreement with the experiment results. The wheel hub was composed of nonuniform α and β phases. The lath α phase precipitated from larger β grains with different orientations. Compared with the other samples at different locations, the α phase in the PM sample (middle of the TC4 wheel hub) displayed high peak intensity and uniformly distributed β phase along the radial direction of the wheel hub. Moreover, the PM sample revealed a higher tensile strength of 820 MPa and similar Vickers hardness of 318 HV compared with the other samples at different locations, which were higher than those of rolling and extrusion molding. This experiment design would provide a good reference for the vertical centrifugal casting of the TC4 alloy.

Parameter Optimization of Al-5Mg-3Zn-1Cu Basin-Shaped Centrifugal Casting: Simulation and Experimental Verification

Process Optimization of Low-pressure Die Casting of Aluminum Alloy Wheel based on Taguchi Method

Experimental and numerical studies on the influence of centrifugal casting parameters on the solidification structure of Al-Cu alloy

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Optimization of Centrifugal Casting Process Parameters by Taguchi Method to Reduce Shrinkage Porosity Ratio of K417 Superalloy

Centrifugal Casting Simulation and Physical Field Analysis of ZL107

Microstructure and hot tearing sensitivity simulation and parameters optimization for the centrifugal casting of Al-Cu alloy

Research on Optimization Design of Cast Process for TiAl Case Casting

Numerical Simulation of Process of Cavity Filling and Solidifying in Tial Alloy Investment Casting

Optimization of Casting System Structure Based on Genetic Algorithm for A356 Casting Quality Prediction

Numerical Simulation of Solidification Structure of Al Alloy During Centrifugal Casting

Numerical Simulation of Vertical Centrifugal Casting Process for Complex Ti Alloy Casting

Optimizing the Gating System for Rapid Investment Casting of Shape Memory Alloys: Computational Numerical Analysis for Defect Minimization in a Simple-Cubic Cell Structure

Numerical Simulation and Process Optimization of Vacuum Investment Casting for Be–Al Alloys

Numerical simulation and optimization in solidification of zinc alloy

Optimization of low-pressure die casting process parameters for reduction of shrinkage porosity in ZL205A alloy casting using Taguchi method

Coupling Simulation and Mechanism Analysis of Grain Formation and Growth in Horizontal Centrifugal Casting

Design of Casting Process for Thick Walled Casting and Optimization of Numerical Simulation

Numerical Simulation and Optimization of Casting Process for Complex Pump

Casting Defects of Ti-6al-4v Alloy in Vertical Centrifugal Casting Processes with Graphite Molds

Numerical Simulation on Solidification during Vertical Centrifugal Casting Process for TC4 Alloy Wheel Hub with Enhanced Mechanical Properties