Abstract:It is known that Ni-based superalloys experience microstructural rafting during high temperature straining. This paper presents a comparative study of the different rafting models by means of finite element modeling and experimentation investigation. It was found that uniaxial elastic loading does not alter the misfit or misfit isotropy of the structure, but causes repartitioning of the misfit into elastic strains in the γ and γ' phases. This causes an elastic strain energy anisotropy and hydrostatic stress anisotropy among the vertical and horizontal γ phase channels. Both anisotropies predict a raft structure that is contrary to the experimental observation. Through a carefully designed pre-treatment at 750 °C and under a uniaxial stress of 750 MPa, an anisotropic dislocation structure was created on the {001} γ'/γ interfaces without altering the cuboidal morphology of the γ' phase. This allows the evaluation of the influence of dislocations on the rafting behavior of the alloy. It was found that rafting occurred in the pre-treated samples containing anisotropic dislocation structures during thermal exposure without applied stress, instead of isotropic corsening, and that the raft structures conform to the expectations base don the anistropic dislocation strucutres. This demonstrates that an anisotropic dislocation structure on the {001} γ'/γ interfaces is a direct cause of rafting. This is attributted to the fact that dislocations on γ'/γ interfaces help to relax the local misfit strains, causing some to expand at the expense of others. At the same time, the formation of the anisotropic dislocation structure is a direct result of the anisotropy of elastic strains induced by the applied bia stess in during the pre-treatment. These explain the complex interplay of the elastic and plastic models reported the literature.

Quantitative Correlation Between Rafting Microstructure and Anisotropic Mechanical Behavior in Dual-Phase Materials

Constitutive modeling of mechanical behaviors in gradient nanostructured alloys with hierarchical dual-phased microstructures

Machine Learning and Materials Informatics Approaches for Predicting Transverse Mechanical Properties of Unidirectional CFRP Composites with Microvoids

Micromechanical Simulation on Strength and Ductility of Two Kinds of Al-based Nanostructural Materials

Micro-Scale Modeling of Anisotropy Effects on Undrained Behavior of Granular Soils

Correlation Between Rheological Behavior and Structure of Multi-Component Polymer Systems

A Comparative Study of Rafting Mechanisms of Ni-based Single Crystal Superalloys

An Effective Model for the Elastic Behavior of Two-Phase Materials Based on Structural Recognition

Elastic Microplane Formulation for Transversely Isotropic Materials

Microstructures and viscoelastic properties of anisotropic magnetorheological elastomers

Correlation structure in the elasticity tensor for short fiber-reinforced composites

Monotonic tensile and cyclic deformation of a Ni-based single crystal superalloy with anisotropic microstructural rafting patterns at high temperature: Experiment and constitutive modelling

Rheological Study of Microstructures and Properties for Polymeric Materials

Macroscopic model with anisotropy based on micro-macro informations

Structural modeling and mechanical research of carbon nanotube reinforced aluminum matrix composites using strain gradient theory

An approach to predict the mechanical properties of CFRP based on cross-scale simulation

Local micromorphic non-affine anisotropy for materials incorporating elastically bonded fibers

Strain localization and failure of disordered particle rafts with tunable ductility during tensile deformation

A microstructure-guided constitutive modeling approach for random heterogeneous materials: Application to structural binders

Constitutive Behavior of Titanium Alloy with Dual-Phase Microstructures: Experiments and Modeling

Micromechanical modeling for longitudinal tensile property of unidirectional CFRP considering dispersion of fiber properties