Abstract:The inflatable membrane structure has been widely used in the fields of civil building, industrial building, airship, super pressure balloon and spacecraft. It is important to measure the stress distribution of the inflatable membrane structure because it influences the safety of the structural design. This paper presents an innovative methodology for the measurement and determination of the stress distribution of the inflatable membrane structure under different internal pressures, combining photogrammetry and the force-finding method. The shape of the inflatable membrane structure is maintained by the use of pressurized air, and the internal pressure is controlled and measured by means of an automatic pressure control system. The 3D coordinates of the marking points pasted on the membrane surface are acquired by three photographs captured from three cameras based on photogrammetry. After digitizing the markings on the photographs, the 3D curved surfaces are rebuilt. The continuous membrane surfaces are discretized into quadrilateral mesh and simulated by membrane links to calculate the stress distributions using the force-finding method. The internal pressure is simplified to the external node forces in the normal direction according to the contributory area of the node. Once the geometry x, the external force r and the topology C are obtained, the unknown force densities q in each link can be determined. Therefore, the stress distributions of the inflatable membrane structure can be calculated, combining the linear adjustment theory and the force density method based on the force equilibrium of inflated internal pressure and membrane internal force without considering the mechanical properties of the constitutive material. As the use of the inflatable membrane structure is attractive in the field of civil building, an ethylene-tetrafluoroethylene (ETFE) cushion is used with the measurement model to validate the proposed methodology. The comparisons between the obtained results and numerical simulation for the inflation process of the ETFE cushion are performed, and the strong agreements demonstrate that the proposed methodology is feasible and accurate.

The Research on the Damping of Prestressed Membrane Structure Subjected to the Impact Load

The Experimental Study on the Vibration of Membrane Structure under Impact Load

Experiment and simulation analysis on dynamic response of plane cable-membrane structure under impact load

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Analysis of Wind-induced Vibration Effects of a Funnel-shaped Open Membrane Structure

ANALYSIS OF SUPPORT DISPLACEMENT EFFECT ON SADDLE-SHAPED MEMBRANE STRUCTURE

Effects of Air on Modal Behavior of Pre-Stressed Membrane Structure

Random vibration of composite saddle membrane structure under the impact loading

An Experimental Study on a Damping System for Strong Impact

Investigation into the Impact and Buffering Characteristics of A Non-Newtonian Fluid Damper: Experiment and Simulation

Modal behaviors and influencing factors analysis of inflated membrane structures

Modal Identification Experimental Investigations and Calculation Method for Biaxial Tensioned Membranes

Dynamic Performance Improving of MEMS Sensor By Gas Damping Structure

An Innovative Methodology for Measurement of Stress Distribution of Inflatable Membrane Structures

Dynamic response of saddle membrane structure under hail impact

Analysis of damping performance of frame structure with viscoelastic dampers

Study on the Characteristics of Gas Spring-Damping Modified Model Bladder-Damper Based on Dynamic Mesh Technology

Random vibration of pretensioned rectangular membrane structures under heavy rainfall excitation

The Added Mass of a Biaxial Tensioned Membrane in Still Air

Damping Model of Fiber Reinforced Composites and Factors Affecting Damping and Dynamic Response

The Study On Friction Damping Technology With Constraint Friction Layer