Abstract:The use of a binary cycle coupled to the complete reinjection of non-condensable gases could provide a valid answer to the improvement of the sustainability of geothermal plants. In recent years, the interest in the use of CO2 as a working fluid in transcritical cycles has increased. However, the low critical temperature of carbon dioxide (≈30 °C) requires the cooling cycle, temperatures below 15 °C, which are not always available. In this work, to overcome this limitation and obtain a higher critical temperature and a lower maximum pressure for more flexible applications of transcritical binary cycles, the possibility of using a second component, mixed with CO2, has been evaluated. For this purpose, the following fluids have been proposed: R1234yf, R1234ze(E), n-butane, n-hexane, n-pentane, and propane, with a minimum considered carbon dioxide molar content of 60%. To carry out a cycle analysis, the knowledge of the thermodynamic properties of CO2-mixtures is fundamental; however, suitable equations of state under the appropriate conditions for these blends have not been clearly defined yet. Therefore, in the first part of this paper, different EoS for predicting thermodynamic properties of pure CO2 and CO2-based mixtures are analyzed and compared with reference data obtained from works published in the literature. However, because of the lack of experimental data of the selected blends, the values of density, enthalpy and entropy, obtained with the selected EoS, are compared with NIST REFPROP results. The EoS involved in the evaluation are cubic-type (PR, PR-Twu, PRSV, RK, SRK, GCEOS), Virial-type (LKP, BWRS), Helmholtz-type (SW), and SAFT-type (PC-SAFT). In a power cycle, the fluid works under different conditions, involving several possible states across the components. So the influence of the different EoS on each power cycle's key component for pure CO2 and two selected CO2-based mixtures has been investigated. The thermodynamic results show that the CO2-based mixtures, in a transcritical configuration, can achieve efficiencies higher than the sCO2 power cycle.

Comparative Study on Critical Points of Carbon Dioxide-Based Binary Mixtures

Measurement And Modeling Of The High-Pressure Phase Behavior Of The Carbon Dioxide Plus Propene Oxide Binary System

Critical Points Calculation of CO2-based Binary Mixture Working Fluids: Evaluation of PC-SAFT Equation of State

Prediction of critical points for carbon dioxide-based binary mixtures by the Heidemann-Khalil approach

Experimental investigation of critical parameters for the binary mixture of CO 2 + R1336mzz(Z) (cis-1,1,1,4,4,4-hexafluoro-2-butene) and analysis of critical locus for CO 2 + hydrofluoroolefin systems

A Potentially Non-Contact Monitor Method for CO2 at the Pseudo-Critical Region Using Infrared Spectrometer

Performance Analysis and Comparison Study of Transcritical Power Cycles Using Co2-Based Mixtures As Working Fluids

On the Role of Critical Properties in CO2-based Binary Mixture Transcritical Rankine Cycle Performance

Evaluation of the property methods for pure and mixture of CO2 for power cycles analysis

Thermo-economic Analysis and Comparative Study of Transcritical Power Cycles Using CO2-based Mixtures As Working Fluids

Investigation on the effect of mixtures physical properties on cycle efficiency in the CO2-based binary mixtures Brayton cycle

Assessment of Ternary CO2 Mixtures As Working Fluids in Supercritical Brayton Cycles with Floating Critical Points

Combustion Characteristic and Mechanism of a Mixture Working Fluid C3H8/CO2

Measurements of Critical Properties for Carbon Dioxide (CO2) + Propylene (R-1270) Binary Mixture

Exergetic, Economic and Exergo-Environmental Analysis of Bottoming Power Cycles Operating with CO2-Based Binary Mixture

Off-design Performance Analysis of Supercritical CO2 Mixture Brayton Cycle with Floating Critical Points

Measurement of bubble points, dew points and critical points of carbon dioxide/vinyl chloride binary system

Off-design performance analysis of supercritical CO 2 mixture Brayton cycle with floating critical points

Computer-aided molecular design of CO 2 -based mixture working fluid harvesting engine waste heat

Thermodynamic Comparison of CO2 Power Cycles and Their Compression Processes

Vapor-liquid Equilibrium Measurement for Carbon Dioxide (co2)+propylene (R1270) Binary Mixture at Temperatures from Subcritical to Supercritical