Abstract:Phase change materials are used in passive solar house construction with light steel structure walls, which can overcome the problems of weak heat storage capacity and poor utilization of solar heat and effectively solve the thermal defects of light steel structure walls. Based on this, on the basis of preliminary experimental research, this study further carried out theoretical analysis and simulation research on the thermal performance of a light steel structure passive solar house (Trombe form) with PCM walls. Through the heat balance analysis of heat transfer in the heat collecting partition wall, the theoretical calculation formula of the phase change temperature of the PCM was obtained, and it verified theoretically that the phase change temperature value should be 1–3 °C higher than the target indoor air temperature. The evaluation index “accumulated daily indoor temperature offset value” was proposed for evaluating the effect of phase change materials on the indoor temperature of the passive solar house, and “EnergyPlus” software was used to study the influence of the phase change temperature, the amount of material, and the thickness of the insulation layer on the indoor air temperature in a natural day. The results showed that there was a coupling relationship among the performance and between of the thickness of the PCM layer and the phase change temperature. Under typical diurnal climate conditions in the northern Tibetan Plateau of China, the optimal combination of the phase change temperature and the layer thickness was 17 °C and 15 mm, respectively. Especially at a certain temperature, excessive increases in the thickness of the phase transition layer could not improve the indoor thermal environment. For this transition temperature, there exists an optimal transition layer thickness. For a Trombe solar house, the thickness of the insulation layer has an independent impact on indoor temperature compared to other factors, which has an economic value, such as 50 mm in this case. In general, this paper studied the relationship between several important parameters of the phase change wall of a solar house by using numerical simulation methods and quantitatively calculated the optimal parameters under typical meteorological conditions, thus providing a feasible simulation design method for similar engineering applications.

Improving the Indoor Thermal Environment in Lightweight Buildings in Winter by Passive Solar Heating: an Experimental Study

Energy Efficiency For Airtightness And Exterior Wall Insulation Of Passive Houses In Hot Summer And Cold Winter Zone Of China

Thermal Performance Optimization Simulation Study of a Passive Solar House with a Light Steel Structure and Phase Change Walls

Numerical simulations on the thermal performance of ventilated walls with passive solar heating and latent heat storage in winter

Towards Zero Energy Buildings: A Novel Passive Solar House Integrated with Flat Gravity-Assisted Heat Pipes

Evaluation of energy-saving potential and indoor thermal environment of passive solar houses in various heating climate regions of China

Analytical Optimization of Interior PCM for Energy Storage in a Lightweight Passive Solar Room

Solar Application Potential and Thermal Property Optimization of a Novel Zero-Carbon Heating Building

Experimental study on heat transfer and storage of a heating system coupled with solar flat heat pipe and phase change material unit

Exploring Building Component Thermal Storage Performance for Optimizing Indoor Thermal Environment – A Case Study in Beijing

Assessment of an Integrated Active Solar and Air-Source Heat Pump Water Heating System Operated Within A Passive House in A Cold Climate Zone

A New Method to Estimate Optimal Phase Change Material Characteristics in A Passive Solar Room

Experimental Study on the Thermal Performance of the Shape-Stabilized Phase Change Material Floor Used in Passive Solar Buildings

Experimental Study on Phase Change Material with Solar Heater System for Building Heating

Ideal Non-Linear Thermal Properties Of Building Internal Thermal Mass In A Passive Solar Room Based On A Simplified Thermal Model

Theoretical Analysis on the Building Internal Thermal Mass in Passive Solar House Based on a Simplified Thermal Model

Study on the influence of thermo-physical parameters of phase change material panel on the indoor thermal environment of passive solar buildings in Tibet

Numerical study on thermal comfort and energy-saving potential of a prefabricated temporary house integrated with composite phase change materials

Actual Thermal and Ventilation Environment Fieldwork Test Analysis of Sun Space Design Strategies in a Net-Zero House

Improving thermal performance of a passive ventilation and cooling system by integrating a phase-change material: Dynamic characteristics and parametric examinations

The Significance for Solar Heat Gain on the Indoor Thermal Environment of Passive Houses in Cold Areas in China