Abstract:A novel system based on the indirect oxy-combustion of coal in a liquid Sb anode solid oxide fuel cell (SOFC) has been used to produce electricity for over 48 h. Pulverized anthracite was fed to the liquidantimony-anode of the fuel cell, and a peak power density of 47 mW cm(-2) was reached at 1023 K and 35 mW cm(-2) at 973 K. The fuel cell was prepared using a porous stainless-steel tube as a support for an LSM cathode. antimony oxide (Sb2O3)/yittria stabilized zirconia (YSZ, Y(0.08)Z(0.92)O(1.96)) composite electrolyte (membrane), while liquid antimony acted as the anode. Liquid antimony/antimony oxide served as the intermediate medium for coal oxidation producing mainly carbon dioxide, which evolved as a separate gas stream. The fuel cell will facilitate carbon capture process, and simultaneously convert the chemical energy of coal directly to electricity. The experiment showed that while the fabricated electrolyte was porous, it became dense during the actual operation, preventing nitrogen leakage into the Sb/C side and producing reasonable open circuit voltage. Analysis of the experimental EIS data illustrates that the Ohmic resistance was the primary loss mechanism in the system. It further suggests approaches to improve the design. Continuous operation of this coal fueled oxy-combustion/fuel cell system achieved an overall efficiency of 28.2% despite of its tiny scale. Simple technologies can be employed to scale up this system at relatively low cost of fabrication and materials. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Co-generation of Gas and Electricity on Liquid Antimony Anode Solid Oxide Fuel Cells for High Efficiency, Long-Term Kerosene Power Generation

Liquid Antimony Anode for Converting Sulfur-Containing Coal in Direct Carbon Fuel Cells

Oxy-combustion of Coal in Liquid-Antimony-anode Solid Oxide Fuel Cell System

Co-Generation of Electricity and Chemicals via Solid Oxide Fuel Cells Using Li-Doped LSGM and LSF Composite Anodes

Direct Carbon Fuel Conversion in a Liquid Antimony Anode Solid Oxide Fuel Cell

Development of Liquid Antimony Anode-Based Fuel Cells: Effects of Reaction-Induced Convection on Mass Transfer and Electrochemical Performance

Direct Ammonia-Fed Liquid Metal Anode Solid Oxide Fuel Cell for Co-Generation of Hydrogen and Electricity

Anode Catalysts for Solid Oxide Fuel Cells That Run Directly on Hydrocarbon Fuels

Liquid Antimony Anode Fluidization Within A Tubular Direct Carbon Fuel Cell

Sulfur-Resistant Liquid Antimony Anode for Direct Carbon Fuel Cells

Fabrication and performance of atmospheric plasma sprayed solid oxide fuel cells with liquid antimony anodes

Co-generation of liquid chemicals and electricity over Co-Fe alloy/perovskite anode catalyst in a propane fueled solid oxide fuel cell

Introducing Anode Fluidization into a Tubular Liquid Antimony Anode Direct Carbon Fuel Cell

Cycling Characteristics of Tubular Liquid Antimony Anode Direct Carbon Fuel Cells Prepared by Atmospheric Plasma Spray

Performance Enhancement of Liquid Antimony Anode Fuel Cell by In-Situ Electrochemical Assisted Oxidation Process

A Solid Oxide Fuel Cell Runs on Hydrocarbon Fuels with Exceptional Durability and Power Output

Highly-efficient Conversion of Lignin to Electricity by Nickel Foam Anode Loaded with Solid Electrocatalysts

Co-Generation of Electricity and Syngas on Proton-Conducting Solid Oxide Fuel Cell with A Perovskite Layer As A Precursor of A Highly Efficient Reforming Catalyst

Conversion of CO 2 through solid oxide co-electrolysis cell with cobalt-free fuel electrode

Surface-engineered ceramic anode with asymmetric microchannels for efficient power and syngas co-generation in solid oxide fuel cells

Direct liquid methanol-fueled solid oxide fuel cell