Abstract:There are heat transfer correlations for heat transfer analysis in single tube geometries after several experimental and theoretical heat transfer studies in these single tube geometries. This is not the case for heat transfer analysis in rod bundle geometry with regard to proposed square fuel assembly of the Supercritical-Water-Cooled Reactor (SCWR) European Atomic Energy (EURATOM) design. Thus limited heat transfer studies exist on rod bundle geometry at supercritical pressures. Heat transfer correlations with accurate prediction capabilities of coolant and wall temperatures will be helpful in carrying out heat transfer studies at supercritical pressures. This paper presents the performance of twelve selected heat transfer correlations assessed on the 1/8th bare square fuel assembly of the SCWR EURATOM design using Simulation of Turbulent flow in Arbitrary Regions Computational Continuum Mechanics C ++ based code (STAR-CCM + CFD code). The obtained numerical results were compared with the results obtained by Waata numerical experimentation. Overall, the Cheng et al. correlation provided the most satisfying prediction for the wall temperatures in all the sub-channels and captured closely Wataa's Numerical data. The maximum wall temperature was obtained in sub-channel 9, the hottest sub-channel and exceeded the design limit 620 °C by 60 °C for the Cheng correlation. The difference in temperature between the hottest and coldest sub-channels 9 and 1 respectively was approximately 80 °C. It was found that Cheng correlation is best suited for heat transfer prediction in rod bundle geometry at supercritical pressures with regard to the proposed square fuel assembly of the SCWR EURATOM design. It was also found that the different numerical tools adopted for this study and Waata study were able to capture the trends of normal, enhanced and deteriorated heat transfer regimes normally observed at supercritical pressures. Nevertheless, experimental investigations involving rod bundles adopted in this study should be conducted to validate the results obtained numerically and address the inconsistency of the conclusions drawn when compared with Waata data and other similar studies.

Development of Heat Transfer Correlation of Turbulent Forced Convection in Subchannels with Rough Surfaces Based on CFD

Detailed Heat Transfer Measurements of Curved Fin Channels

A Correlation Of Heat Transfer Non-Uniformity In Rod Bundle And Its Application To Sub-Channel Code

Development of Nusselt number and friction factor models for rough rod bundles based on wall functions

Investigation on Turbulent Heat Transfer to Lead-Bismuth Eutectic Flows in Rough Rod Bundles for Nuclear Applications

Development of Friction Factor Correlations for Hexagonal and Square Bundles with Rough Rods Based on CFD

Friction Factor and Nusselt Number Correlations for Forced Convection in Helical Tubes

Convective Heat Transfer Coefficient for a Rod-Like Particle in a Uniform Flow

Nonuniform Heat Transfer of Supercritical Water in a Tight Rod Bundle – Assessment of Correlations

Development of friction factor and heat transfer correlation of liquid metal flow in helical tube bundles

Numerical Investigation for the Heat Transfer Mechanisms Between Subchannels of Bar Rod Bundles Cooled by Liquid Sodium

Study of the Hydraulic Roughness Impact on Turbulent Heat Transfer at Supercritical Pressure Based on a Fast Direct Numerical Simulation Method

Experimental Study of Single-Phase Flow and Heat Transfer in Rectangular Channels under Uniform and Non-Uniform Heating

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

Numerical Investigation on Saturated Boiling and Heat Transfer Correlations in A Vertical Rectangular Minichannel

An Experiment Study of Pressure Drop and Flow Distribution in Subchannels of a 37-Pin Wire-Wrapped Rod Bundle

Heat Transfer and Friction Characteristics in Steam Cooled Rectangular Channels with Rib Turbulators

New pressure drop and heat transfer correlations for turbulent forced convection in internally channeled tube heat exchanger ducts

Analysis of Local Heat Transfer Characteristics of Water and Steam in Helically-Coiled Tube

Numerical Simulation of Turbulent Flow and Heat Transfer in Multi‐channel, Narrow‐gap Fuel Element

Numerical Analysis on Supercritical Water Heat Transfer in a 2 × 2 Rod Bundle