Abstract:There are heat transfer correlations for heat transfer analysis in single tube geometries after several experimental and theoretical heat transfer studies in these single tube geometries. This is not the case for heat transfer analysis in rod bundle geometry with regard to proposed square fuel assembly of the Supercritical-Water-Cooled Reactor (SCWR) European Atomic Energy (EURATOM) design. Thus limited heat transfer studies exist on rod bundle geometry at supercritical pressures. Heat transfer correlations with accurate prediction capabilities of coolant and wall temperatures will be helpful in carrying out heat transfer studies at supercritical pressures. This paper presents the performance of twelve selected heat transfer correlations assessed on the 1/8th bare square fuel assembly of the SCWR EURATOM design using Simulation of Turbulent flow in Arbitrary Regions Computational Continuum Mechanics C ++ based code (STAR-CCM + CFD code). The obtained numerical results were compared with the results obtained by Waata numerical experimentation. Overall, the Cheng et al. correlation provided the most satisfying prediction for the wall temperatures in all the sub-channels and captured closely Wataa's Numerical data. The maximum wall temperature was obtained in sub-channel 9, the hottest sub-channel and exceeded the design limit 620 °C by 60 °C for the Cheng correlation. The difference in temperature between the hottest and coldest sub-channels 9 and 1 respectively was approximately 80 °C. It was found that Cheng correlation is best suited for heat transfer prediction in rod bundle geometry at supercritical pressures with regard to the proposed square fuel assembly of the SCWR EURATOM design. It was also found that the different numerical tools adopted for this study and Waata study were able to capture the trends of normal, enhanced and deteriorated heat transfer regimes normally observed at supercritical pressures. Nevertheless, experimental investigations involving rod bundles adopted in this study should be conducted to validate the results obtained numerically and address the inconsistency of the conclusions drawn when compared with Waata data and other similar studies.

Nonuniform Heat Transfer of Supercritical Water in a Tight Rod Bundle – Assessment of Correlations

Experimental Investigation on Heat Transfer to Supercritical Water in a Three-Rod Bundle with Spacer Grids

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

Assessment of Heat-Transfer Correlations Against Experimental Data Obtained with Supercritical Water in Vertical Annuli

Heat Transfer Characteristics of Supercritical Water in a 2 × 2 Rod Bundle – Numerical Simulation and Experimental Validation

A New Correlation For Heat Transfer Coefficient Prediction Of Supercritical Pressure Water Flowing In Vertical Upward Tubes

Numerical Analysis on Supercritical Water Heat Transfer in a 2 × 2 Rod Bundle

A Correlation Of Heat Transfer Non-Uniformity In Rod Bundle And Its Application To Sub-Channel Code

Experimental Study Of Heat Transfer To Supercritical Pressure Water Flowing In A 2x2 Rod Bundle

Analysis of Heat Transfer Characteristics in Core of Supercritical Water Cooled Reactor

Numerical Study on the Thermohydraulics of Near-Critical Water in Rod Bundle with Spacer Grids

Heat Transfer Characteristics of Supercritical Water in Annular Flow Channel

Heat Transfer from a 2 × 2 Wire-Wrapped Rod Bundle to Supercritical Pressure Water

A New Heat Transfer Correlation for Supercritical Fluids

A Review on Recent Heat Transfer Studies to Supercritical Pressure Water in Channels

Experimental study on heat transfer in vertical cooling tube cooled by downward flow in the passive heat removal system of SCWR

Experimental Investigation of the Pressure Drop and Friction Factor of Supercritical Water in a 2 × 2 Rod Bundle

Wide-ranged Heat Transfer Correlations of Supercritical Water in Vertical Upward Channels

Experimental Investigation of Heat Transfer from a 2 × 2 Rod Bundle to Supercritical Pressure Water

Prediction of Critical Heat Flux in Non-Uniform Heated Rod Bundle Based on Modified CHF Empirical Correlations

Discussion and perspectives for improvements of heat transfer correlation capabilities for fluids at supercritical pressures