Abstract:Owing to the low flow field disturbances and fast response, thin-film thermocouples (TFTCs) are used to measure the service temperature of aero-engines. Indium tin oxide (ITO) and In2O3 are widely used in high-temperature measurements. However, ITO undergoes phase transition and consequent thermoelectric failure at above 1300 degrees C. In this study, In1.35ZnO2.11/In2O3 TFTCs were prepared on alumina substrates via screen printing method through introduction of ZnO nanopowder followed by annealing treatment. Results show that prepared TFTCs exhibited good thermoelectric properties at 1500 degrees C. The morphology, structure, and electrical coefficients of TFTCs were investigated. The average Seebeck coefficient was 39.8 mu V/degrees C at 1500 degrees C with a drift rate (DT) of 0.84 degrees C/h, which was significantly improved with respect to that of ITO/In2O3, corresponding to 44.5 mu V/degrees C at 1270 degrees C with a DT of 5.44 degrees C/h and failed at higher temperature. The result of lumped capacity method test show that the response time was 4.8 ms at 100 degrees C. Preliminary engine gas temperature measurements with a heat load of 1000 degrees C at 1 Mach show that these TFTCs are promising candidates for engineering applications. Finally, the structural reliability under high-magnitude vibration and impact tests (10-2000 Hz/20 g and 100 g/(-)(1) ms) was also investigated. As a result of the excellent bonding strengths of 47.36 and 59.83 N between the film and the substrate for both In1. 35ZnO2.11 and In2O3, respectively, destructive cracking and peeling of the film were not observed, and no change in the Seebeck coefficient of the sample occurred after impact and vibration tests. These results provide an important basis for the potential application of In1.35ZnO2.11/In2O3 TFTCs in aero-engine high-temperature measurements of flow channel components.

Thermoelectricity and Antivibration Properties of Screen-Printed Nanodoped In1.35ZnO2.11/In2O3 Thin-Film Thermocouples on Alumina Substrates

Optimization on Thermoelectric Characteristics of Indium Tin Oxide/indium Oxide Thin Film Thermocouples Based on Screen Printing Technology.

High Temperature Thermoelectric Properties of Nitrogen Doped ITO Thin Films

Nano Cone ITO Thin Films Prepared by Pulsed Laser Deposition for Surface Measurement of High-Temperature Components

High Temperature Resistant Thin Film Thermocouple Prepared Based on Inkjet Printing

Microstructure and thermoelectric properties of In2O3/ITO thin film thermocouples with Al2O3 protecting layer

Sandwich Probe Temperature Sensor Based on In2O3-IZO Thin Film for Ultra-High Temperatures

Study on Aluminium Oxide Doping Modification of Indium Oxide and Thermoelectric Properties

A Highly Thermostable In2O3/ITO Thin Film Thermocouple Prepared via Screen Printing for High Temperature Measurements

Fabrication and Characterization of La0.8Sr0.2CrO3/In2O3 Thin Film Thermocouple for High Temperature Sensing

Preparation and Thermoelectric Characteristics of ITO/PtRh:PtRh Thin Film Thermocouple

Fabrication and performance study of high temperature thin film sensor

Enhanced Stability of ITO/In2O3 Thin Film Thermocouples by Coating Al2O3 Layer

High-temperature Protection Performance of Mg-doped Al2O3 2 O 3 Protective Layers on the Thin Film Thermocouples

High-Temperature-Sensing Smart Bolt Based on Indium Tin Oxide/In2O3 Thin-Film Thermocouples with Nickel-Based Single-Crystal Superalloy via Screen Printing

Influences of annealing temperature on the thermoelectric properties of thin film thermocouples based on a flexible substrate by RF magnetron sputtering

Thermoelectric properties and microscopic characterization of Hf doped indium oxide thick film thermocouples screen printed on alumina substrates

Screen Printing Silver Shielded ITO-In2O3 Thin-Film Thermocouples for Electromagnetic Interference Reduction

Enhanced La0.8Sr0.2CrO3/Pt Thin Film Thermocouple with Al2O3 Coating Layer for High Temperature Sensing

High temperature protection performance of sandwich structure Al2O3/Si3N4/YAlO multilayer films for Pt–Pt10%Rh thin film thermocouples

ITO Film Prepared by Ion Beam Sputtering and Its Application in High-Temperature Thermocouple