Sensitivity Enhancement for Microbial Fuel Cell Type Oil Sensor by Regulation of Anode Area, External Resistance and Substrate Concentration

Zheqin Dai,Ran Yu,Yifeng Wu,Guangcan Zhu,Xiwu Lu,Xiao Zha
DOI: https://doi.org/10.1016/j.jece.2022.107973
IF: 7.7
2022-01-01
Journal of Environmental Chemical Engineering
Abstract:To promote application of the microbial fuel cell (MFC)-based oil sensor in monitoring oil leak risks of oil pipelines and to overcome the influence of signal fluctuation, the sensor sensitivity needs to be enhanced. Simple and viable start-up measures such as regulating anode area, external resistance and substrate concentration were implemented to investigate their influence on the sensitivity. Results show that enlarging anode area and less -ening external resistance will significantly promote the sensitivity (change of current signal per oil amount). Increasing anode area from 3.1 to 9.6 cm(2) resulted in a 711 % increase in the initial sensitivity and a 358 % increase in the average sensitivity. Decreasing external resistance from 1300 to 400 omega led to a 797 % increase in the initial sensitivity and a 378 % increase in the average sensitivity. While controlling substrate concentration from 155.7 to 500.7 mg-COD/L had a much smaller impact on the sensitivity. Manipulating substrate concen-tration over an augmented range (41.2-500.7 mg-COD/L) showed that insufficient substrate (< 80 mg-COD/L) induced a drastic current drop. A theoretical sensitivity formula was derived from a data fitting model based on charge conservation. The formula reveals that a sensitivity factor relating to the ratio of ORR and oxygen transfer is key to enhancing sensitivity, which was verified to have a strong positive correlation with current by data analysis and EIS. In general, this study shows that measures to elevate current will significantly enhance sensitivity besides keeping substrate concentration at a high level is a prerequisite for maintaining it.
What problem does this paper attempt to address?