Abstract:Suspension plasma spraying (SPS) can be utilized to manufacture finely structured coatings. In this process, liquid suspended with micro- or nano-sized solid particles is injected into a plasma jet. It involves droplet injection, solvent evaporation, and discharge, acceleration, heating, and melting of the solid particles. The high-speed and high-temperature particles finally impact on the substrate wall, to form a thin layer coating. In this study, a comprehensive numerical model was developed to simulate the dynamic behaviors of the suspension droplets and the solid particles, as well as the interactions between them and the plasma gas. The plasma gas was treated as compressible, multi-component, turbulent jet flow, using Navier-Stokes equations solved by the Eulerian method. The droplets and solid particles were treated as discrete Lagrangian entities, being tracked through the spray process. The drag force, Saffman lift force, and Brownian force were taken into account for the aerodynamic drag force, aerodynamic lift force, and random fluctuation force imposed on the particles. Spatial distributions of the micro- and nano-sized particles are given in this paper and their motion histories were observed. The key parameters of spray distribution, including particle size and axial spray distance, were also analyzed. The critical size of particle that follows well with the plasma jet was deduced for the specified operating conditions. Results show that in the downstream, the substrate influences the flow field structure and the particle characteristics. The appropriate spray distances were obtained for different micro- and nano-sized particles.

Analysis of Nucleation, Phase Selection and Rapid Solidification of an Alumina Splat

Phase Selection During Rapid Solidification of Plasma-Sprayed Alumina Splats on an Alumina Substrate

Rapid Solidification in Thermal Spray Deposition: Microstructure and Modelling

Numerical simulation of nucleation, solidification, and microstructure formation in thermal spraying

Nanoparticles Modeling in Axially Injection Suspension Plasma Spray of Zirconia and Alumina Ceramics

An Integrated Model for Dendritic and Planar Interface Growth and Morphological Transition in Rapid Solidification

Studies of splat morphology and rapid solidification during thermal spraying

Numerical study of the melting and resolidification of the substrate during the impact of a ceramic droplet in a plasma spraying process

Effect of Droplet Initial Temperature on Substrate Melting and Its Re-solidification in Plasma Spray Process

Research on the Collision Model of High-Temperature Alumina Droplets with Cold Wall for Solid Rocket Motors

Thermomechanical modeling of a single splat solidification in plasma spraying

A numerical study of thermal shrinkage influence on the impact dynamics of alumina droplets thermally sprayed on flat, grit-blasted and laser treated surfaces

Thermal analysis and measurements for a molten metal drop impacting on a substrate: cooling, solidification and heat transfer coefficient

Thermomechanical Simulation of Single Splat Solidification and Cooling in Plasma Spray Forming

Experiment and model study of rebound/adhesion characteristics of alumina droplets colliding with walls at different temperatures

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Deposition of a Molten Layer of High Melting Point Material: Substrate Melting and Resolidification

Numerical Investigation of Substrate Melting and Deformation During Thermal Spray Coating by SPH Method

Impact of Deposition Temperature on Crystalline Structure of Plasma-Sprayed Al2O3 Splats Revealed by FIB-HRTEM Technique

Characterization of Nonmelted Particles and Molten Splats in Plasma-Sprayed Al2O3 Coatings by a Combination of Scanning Electron Microscopy, X-ray Diffraction Analysis, and Confocal Raman Analysis

Study of splat particle temperature distribution in plasma spray forming