The Process of Self-heating Sludge Incineration Based on Granular Heat Carrier

Kong Hao,Miao Miao,Yang Hairui,Zhang Xuyi,Zhang Man

DOI: https://doi.org/10.1007/978-981-16-1657-0_88

2021-01-01

Abstract:Among the current sludge treatment methods, drying and incineration is one of the most frequently adopted for sludge processing since it works efficiently and can reduce pollution caused by sludge. However, sludge with high moisture content needs a lot of heat for drying before stable burning in the furnace, which increases its cost and causes the stink. This paper introduces a novel process of self-heating sludge incineration based on granular heat carrier as shown in Fig. 88.1. Self-heat incineration means that the process uses self-generating heat for drying and incineration to reduce heat consumption. Free falling particles curtain is used to quickly cool down the flue gas temperature to below 300 °C, to avoid the temperature 300–800 °C that may cause regeneration of dioxin. The particles heated works as heat carrier to dry the wet sludge with water content over 70% in the fluidized bed dryer. The dried sludge is incinerated in the insulated fluidized bed furnace to provide heat to burn other wet sludge directly injected into the furnace. A 240 t/d unit with such process was manufactured and operated in 2017, and the performance is satisfied. SO2 emission is less than 30 mg/Nm3, NOx emission is less than 100 mg/Nm3, PCDD/Fs emission is less than 0.034 ng-TEQ/Nm3 and the investment of this process is less than 250,000 yuan/t/d.