Abstract:This paper presents a wearable anemometer for detecting wind absolute orientation and wind speed, as well as attitude and heading angles by incorporating a micro homemade thermal flow vector sensor with commercial triaxial micro accelerometer and triaxial micro magnetometer. The thermal flow vector sensor is comprised of three roundabout Pt hot-films uniformly distributed in a circle that is fabricated on a polyimide substrate. The flow sensor detects flow speed and flow relative angle in the body coordinate system, which is calculated from the heating powers of three hot-films that are operated in constant temperature difference circuits. The flow relative angle is further converted to the wind absolute orientation in the geographic coordinate system by means of the attitude and heading angle detected by using the triaxial accelerometer and triaxial magnetometer. The power consumption of the whole anemometer is about 400 similar to 500 mW under a wind blowing of 0 similar to 20 m/s. Using a rechargeable lithium battery with a capacity of 600 mAh, the anemometer can he continuously worked for about 4 h. Wind experimental results demonstrate that the root mean square (rms) error of the wind speed measurement reaches 0.17 m/s in the range of 0 similar to 18.9 m/s, the rms errors of wind relative angle and absolute orientation reach 2.79 degrees and 3.22 degrees, respectively, in the range of 0 similar to 360 degrees. Attitude and heading experimental results illustrate that the rms errors of heading and roll measurements reach 0.42 degrees and 0.15 degrees, respectively, in the range of -180 degrees similar to 180 degrees, and the rms error of pitch reaches 0.13 degrees in the range of -90 degrees similar to 90 degrees.

Effect of Wind-Induced Vibration on Measurement Range of Microcantilever Anemometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Design and Optimization of Resonant Cavity Piezoelectric Cantilever Sensor for Wind Velocity and Direction Measurement

The Impact of Wind on Precipitation Measurements from a Compact Piezoelectric Sensor

Vibration of Micro Cantilever Applied in Micro Scale Jet Velocity Measurement

Research on Dust Effect for MEMS Thermal Wind Sensors

Different Effects of Mass and Damping on Performance of Vibration and Wind Energy Harvesters

Field measurements of wind-induced vibration of a structure

Determination of Fluid Density and Viscosity by Analyzing Flexural Wave Propagations on the Vibrating Micro-Cantilever

Flexible MEMS Shear Stress Sensor with Improved Performance for Wind Tunnel Measurements

Performing Magnetic Boundary Modulation to Broaden the Operational Wind Speed Range of a Piezoelectric Cantilever-Type Wind Energy Harvester

DENSITY MEASUREMENT PERFORMANCE IN FLOWING LIQUID USING MICROCANTILEVER-BASED RESONATORS UNDER BENDING AND TORSION VIBRATIONS

The Effect of Environmental Conditions on Designing of a Photonic Crystal Force Sensor

Measurement Errors and Correction of the UAT-2 Ultrasonic Anemometer

Determination of Young's Modulus for Microcantilevers in Atomic Force Microscopy

Simulation And Analysis Of Cantilever-Membrane Structure For Piezoresistive Micro-Accelerometers

Wearable Anemometer with Multi-Sensing of Wind Absolute Orientation, Wind Speed, Attitude, and Heading

Measuring the Mechanical Properties of Micro-Cantilever Sensors

Wind - Induced Vibration Monitoring and Data Analysis Method for High - Rise Buildings

Theoretical analysis and experimental study on the vibration of cantlilever

Direction Error Suppression of Mechanical Wind Sensors by Optimizing the Configuration of Supporting Beams