Abstract:The CoCrNi-based medium-entropy alloys (MEA) have been extensively investigated due to their exceptional mechanical properties at both room and cryogenic temperatures. To investigate the hot deformation behavior and the recrystallization mechanism of the CoCr0.4NiSi0.3 medium-entropy alloy, a series of deformation tests was conducted using the MMS-100 thermal simulation tester, with deformation conditions of 0.001–1 s−1/850–1150 °C. During the hot deformation process, the flow stress initially increases up to its peak value before gradually decreasing towards a steady state level. Higher flow stress levels are observed with increasing strain rate and decreasing deformation temperature. The estimated activation energy for hot deformation of this alloy is approximately 423.6602 kJ/mol. The Arrhenius-type constitutive equation is utilized to establish a modified model while incorporating power dissipation theory and the instability criterion of a dynamic material model to construct power dissipation maps and instability maps. By superimposing these maps, hot processing maps with strains of 0.4, 0.5, and 0.7 are derived. In this investigation, it is observed that regions of instability exclusively occur when the true strain exceeds 0.4. These regions of instability on the hot processing map align well with experimental findings. The suitable range of parameters for hot-working decreases as the true strain increases. The microstructure was analyzed using electron backscatter diffraction and transmission electron microscopy (TEM) techniques. The volume fraction of dynamic recrystallization (DRX) decreases with increasing strain rate but diminishes with rising temperature. The TEM characterization elucidated the mechanism of DRX in this MEA. The presence of the long-period stacking ordered (LPSO) phase was observed in both the face-centered cubic matrix and hexagonal close-packed recrystallized grains under different deformation conditions. The LPSO phase originates from the matrix at a low strain rate, whereas it is generated during recrystallization at a high strain rate. The observed increase in flow stress of the as-cast MEA is primarily attributed to the synergistic effects arising from the interaction of the dislocation with twins and the second phase. The onset of instability is effectively suppressed within a limited range through the formation of coherent second phases such as L12, LPSO, and superlattice structures resulting from phase transitions. These second phases serve as nucleation sites for recrystallization and contribute to the strengthening of dispersion. Furthermore, their interaction with dislocations and twins significantly influences both flow stress behavior and recrystallization kinetics under hot deformation. These findings not only deepen our understanding of the underlying deformation mechanisms governing MEA but also offer valuable insights for designing CoCrNi-based alloys with improved mechanical properties at elevated temperatures.

Dynamically Compressive Behaviors and Plastic Mechanisms of a CrCoNi Medium Entropy Alloy at Various Temperatures

Dynamic Shear Deformation of a CrCoNi Medium-Entropy Alloy with Heterogeneous Grain Structures

Dynamic mechanical responses of the Al<sub>0.1</sub>CoCrFeNi high entropy alloy at cryogenic temperature

Dynamic mechanical responses of the Al0·1CoCrFeNi high entropy alloy at cryogenic temperature

Dynamic impact behavior and deformation mechanisms of Cr(26)Mn(20)Fe20Co(20)Ni(14) high-entropy alloy

Real-time Nanoscale Observation of Deformation Mechanisms in CrCoNi-based Medium- to High-Entropy Alloys at Cryogenic Temperatures

Enhanced Strength and Plasticity of CoCrNiAl0.1Si0.1 Medium Entropy Alloy via Deformation Twinning and Microband at Cryogenic Temperature

Microstructure and Texture Evolution of a Dynamic Compressed Medium-Entropy CoCr<sub>0.4</sub>NiSi<sub>0.3</sub> Alloy

Probing Deformation Mechanisms of a FeCoCrNi High-Entropy Alloy at 293 and 77 K Using in Situ Neutron Diffraction

Compressive Mechanical Properties of Gradient Structured CrCoNi Medium-Entropy Alloy under High-Temperature and High-Strain-Rate Coupling

Extensive Phase Transformation in an Equiatomic CrCoNi Medium Entropy Alloy under Extreme Uniaxial Tension

Investigation of the Hot Deformation Behavior and Mechanism of a Medium-Entropy CoCr0.4NiSi0.3 Alloy

Superior Strength-Ductility Synergy and Strain Hardenability of Al/Ta Co-Doped NiCoCr Twinned Medium Entropy Alloy for Cryogenic Applications

Dynamic tensile mechanisms and constitutive relationship in CrFeNi medium entropy alloys at room and cryogenic temperatures

Effect of Temperature and Strain Rate on Quasi-Static and Dynamic Compressive Behavior of Forged CrMnFeCoNi High Entropy Alloy

Hot Deformation and Dynamic Recrystallization Behavior of CoCrNi and (cocrni)94ti3al3 Medium Entropy Alloys

Dynamic Deformation Behavior of a FeCrNi Medium Entropy Alloy

Precipitation and heterogeneous strengthened CoCrNi-based medium entropy alloy with excellent strength-ductility combination from room to cryogenic temperatures

Exceptional high-strain-rate tensile mechanical properties in a CrCoNi medium-entropy alloy

High Impact Toughness of CrCoNi Medium-Entropy Alloy at Liquid-Helium Temperature

Real-time Atomic Deformation Behavior of Nano CoCrCuFeNi High-Entropy Alloy