Abstract:The CoCrNi-based medium-entropy alloys (MEA) have been extensively investigated due to their exceptional mechanical properties at both room and cryogenic temperatures. To investigate the hot deformation behavior and the recrystallization mechanism of the CoCr0.4NiSi0.3 medium-entropy alloy, a series of deformation tests was conducted using the MMS-100 thermal simulation tester, with deformation conditions of 0.001–1 s−1/850–1150 °C. During the hot deformation process, the flow stress initially increases up to its peak value before gradually decreasing towards a steady state level. Higher flow stress levels are observed with increasing strain rate and decreasing deformation temperature. The estimated activation energy for hot deformation of this alloy is approximately 423.6602 kJ/mol. The Arrhenius-type constitutive equation is utilized to establish a modified model while incorporating power dissipation theory and the instability criterion of a dynamic material model to construct power dissipation maps and instability maps. By superimposing these maps, hot processing maps with strains of 0.4, 0.5, and 0.7 are derived. In this investigation, it is observed that regions of instability exclusively occur when the true strain exceeds 0.4. These regions of instability on the hot processing map align well with experimental findings. The suitable range of parameters for hot-working decreases as the true strain increases. The microstructure was analyzed using electron backscatter diffraction and transmission electron microscopy (TEM) techniques. The volume fraction of dynamic recrystallization (DRX) decreases with increasing strain rate but diminishes with rising temperature. The TEM characterization elucidated the mechanism of DRX in this MEA. The presence of the long-period stacking ordered (LPSO) phase was observed in both the face-centered cubic matrix and hexagonal close-packed recrystallized grains under different deformation conditions. The LPSO phase originates from the matrix at a low strain rate, whereas it is generated during recrystallization at a high strain rate. The observed increase in flow stress of the as-cast MEA is primarily attributed to the synergistic effects arising from the interaction of the dislocation with twins and the second phase. The onset of instability is effectively suppressed within a limited range through the formation of coherent second phases such as L12, LPSO, and superlattice structures resulting from phase transitions. These second phases serve as nucleation sites for recrystallization and contribute to the strengthening of dispersion. Furthermore, their interaction with dislocations and twins significantly influences both flow stress behavior and recrystallization kinetics under hot deformation. These findings not only deepen our understanding of the underlying deformation mechanisms governing MEA but also offer valuable insights for designing CoCrNi-based alloys with improved mechanical properties at elevated temperatures.

Dynamic Deformation Behavior of a FeCrNi Medium Entropy Alloy

Dynamic impact behavior and deformation mechanisms of Cr(26)Mn(20)Fe20Co(20)Ni(14) high-entropy alloy

Dynamic Shear Deformation of a CrCoNi Medium-Entropy Alloy with Heterogeneous Grain Structures

Dynamic tensile mechanisms and constitutive relationship in CrFeNi medium entropy alloys at room and cryogenic temperatures

Dislocation Mediated Dynamic Tension-Compression Asymmetry of a Ni2CoFeV0.5Mo0.2 Medium Entropy Alloy

Transgranular Highly Localized Deformation and Fracture Mechanism in Ductile CrFeNi Medium-Entropy Alloys

Strain-rate-dependent Behaviors of CoCrNiSi02 Medium-Entropy Alloy: Deformation Mechanism and Microstructural-Based Constitutive Modeling

Lattice Structures and Mechanical Properties of FeCrNi Medium-Entropy Alloy Prepared by Selective Laser Melting

Strain-rate-dependent behaviors of CoCrNiSi0.2 medium-entropy alloy: Deformation mechanism and microstructural-based constitutive modeling

Strain-rate-dependent behaviors of CoCrNiSi 0 . 2 medium-entropy alloy: Deformation mechanism and microstructural-based constitutive modeling

Unusual phase transformation and novel hardening mechanisms upon impact loading in a medium entropy alloy with dual heterogeneous structure

Microstructure and Texture Evolution of a Dynamic Compressed Medium-Entropy CoCr<sub>0.4</sub>NiSi<sub>0.3</sub> Alloy

Investigation of the Hot Deformation Behavior and Mechanism of a Medium-Entropy CoCr0.4NiSi0.3 Alloy

Dynamically Compressive Behaviors and Plastic Mechanisms of a CrCoNi Medium Entropy Alloy at Various Temperatures

Mechanical properties and deformation mechanisms of a Ni2Co1Fe1V0.5Mo0.2 medium-entropy alloy at elevated temperatures

Cryogenic mechanical behavior of a FeCrNi medium-entropy alloy fabricated by selected laser melting

Microstructures and deformation mechanisms of the medium-entropy alloy (NiCoCr)76(Ni6AlTi)3

Mechanical behavior and shear band of a powder-metallurgy-fabricated CoCrFeMnNi high-entropy alloy during high strain-rate deformation

Mechanical Properties and Shear Localization of High Entropy Alloy CoCrFeMnNi Prepared by Powder Metallurgy

Dynamic Deformation Behavior of a Face-Centered Cubic FeCoNiCrMn High-Entropy Alloy.

Dynamic deformation behaviors and mechanisms of CoCrFeNi high-entropy alloys