Abstract:Though the complementary power field effect transistors (FETs), e.g., metal-oxide-semiconductor-FETs (MOSFETs) based on wide bandgap materials, enable low switching losses and on-resistance, p-channel FETs are not feasible in any wide bandgap material other than diamond. In this paper, we propose the first work to investigate the impact of fixed positive surface charge density on achieving normally-off and controlling threshold voltage operation obtained on p-channel two-dimensional hole gas (2DHG) hydrogen-terminated (C-H) diamond FET using nitrogen doping in the diamond substrate. In general, a p-channel diamond MOSFET demonstrates the normally-on operation, but the normally-off operation is also a critical requirement of the feasible electronic power devices in terms of safety operation. The characteristics of the C-H diamond MOSFET have been analyzed with the two demonstrated charge sheet models using the two-dimensional Silvaco Atlas TCAD. It shows that the fixed-Fermi level in the bulk diamond is 1.7 eV (donor level) from the conduction band minimum. However, the upward band bending has been obtained at Al2O3/SiO2/C-H diamond interface indicating the presence of inversion layer without gate voltage. The fixed negative charge model exhibits a strong inversion layer for normally-on FET operation, while the fixed positive charge model shows a weak inversion for normally-off operation. The maximum current density of a fixed positive interface charge model of the Al2O3/C-H diamond device is - 290 mA/mm, which corresponds to that of expermental result of Al2O3/SiO2/C-H diamond - 305 mA/mm at a gate-source voltage of - 40 V. Also, the threshold voltage Vth is relatively high at Vth = - 3.5 V, i.e., the positive charge model can reproduce the normally-off operation. Moreover, we also demonstrate that the Vth and transconductance gm correspond to those of the experimental work.

Diamond MOSFET with MoO<sub>3</sub>/Si<sub>3</sub>N<sub>4</sub> doubly stacked gate dielectric

Preparation of High Conductivity Hydrogenated Silicon-Doped Diamond and MOSFET

Normally-Off Oxidized Si-Terminated (111) Diamond MOSFETs via ALD-Al 2 O 3 Gate Insulator With Drain Current Density Over 300 mA/mm

Oxidized-silicon-terminated Diamond p-FETs with SiO 2 -fiNing Shallow Trench Isolation Structures

C-Si Interface on Sio2/(111) Diamond P-Mosfets with High Mobility and Excellent Normally-Off Operation

C-Si interface on SiO2/(1 1 1) diamond p-MOSFETs with high mobility and excellent normally-off operation

Performance of hydrogen-terminated diamond MOSFET with LaB6/Al2O3 bilayer dielectric

1 W/mm Output Power Density for H-Terminated Diamond MOSFETs with Al2O3/SiO2 Bi-Layer Passivation at 2 GHz

Performance of hydrogen-terminated diamond MOSFET with LaB<sub>6</sub>/Al<sub>2</sub>O<sub>3</sub> bilayer dielectric

MOSFETs on (110) C–H Diamond: ALD Al2O3/Diamond Interface Analysis and High Performance Normally-OFF Operation Realization

High Performance of Normally‐On and Normally‐Off Devices with Highly Boron‐Doped Source and Drain on H‐Terminated Polycrystalline Diamond

1.26 W/mm Output Power Density at 10 GHz for Si 3 N 4 Passivated H-Terminated Diamond MOSFETs

Recent progress in diamond-based MOSFETs

Electrical Characteristics of Diamond MOSFET with 2DHG on a Heteroepitaxial Diamond Substrate

Electrical Properties of Ge Pmosfets with Ultrathin EOT HfO2/AlOx/GeOx Gate-Stacks and NiGe Metal Source/Drain

4.87 kV SiC MOSFET Using HfSiOx/SiO2 Gate Dielectrics Combined with PN Pillars

An enhanced two-dimensional hole gas (2DHG) C-H diamond with positive surface charge model for advanced normally-off MOSFET devices

Microwave power performance analysis of hydrogen terminated diamond MOSFET

Quantum Dot With a Diamond-Shaped Channel MOSFET on a Bulk Si Substrate

GaN metal-oxide-semiconductor field-effect-transistor with atomic layer deposited Al2O3 as gate dielectric

Vertical-type two-dimensional hole gas diamond metal oxide semiconductor field-effect transistors