Abstract:Duplex stainless steels (DSS) are extensively applied in many fields such as petroleum industry, petrochemistry, desalination service and paper-making industry. They are characterized by a two-phase structure., offering an attractive combination of corrosion resistance and mechanical properties. Their best general properties are obtained by keeping approximately equal volume fractions of austenite and ferrite but averting third harmful phases, such as sigma, gamma(2), chi, carbide and nitride, to be precipitated. These harmful phases can be formed from ferrite when DSS are welded or worked at improper high temperatures. Recently, a kind of economical DSS 2101 of typical composition Fe-21.4Cr-1.2Ni-5.7Mn-0.23N-0.31Mo was developed and shows a wide application potential due to its higher yield strength, better pitting corrosion resistance and lower cost than traditional 304 austenite steel. However, limited research has been dedicated to studying the microstructure and mechanical properties of DSS 2101. Especially research on the nature of precipitations and their effects on mechanical properties in DSS 2101 was still lacking in comparison to many researches on the precipitations in DSS 2205 and DSS 2507. In the present work, it aims at investigating how the precipitations can affect the corrosion resistance of DSS 2101. Pitting corrosion resistance of samples aged at 700 degrees C in 1 mol/L NaCl solution was evaluated by potentiodynamic polarization curve test. The electrochemical potentiokinetic reactivation (EPR) test was also used to evaluate the degree of sensitization to intergranular corrosion. Scanning electron microscopy (SEM) and optical microscopy (OM) were used to observe the surface morphology after electrochemical tests. The results demonstrate that both the resistance to pitting (E-b) and intergranular corrosion (R-a) decreases with aging time increasing. Pitting nucleates preferentially in the ferrite phase for the solution-annealed sample, while the initiation of pitting corrosion takes place around Cr2N, in the newly formed secondary austenite for the aged specimen. EPR tests conducted at room temperature are able to detect the sensitization to R-a due to Cr2N precipitation. With increasing aging time, more Cr2N particles are precipitated at phase interfaces and grain boundaries, causing a continuous decrease of resistance to intergranular corrosion.

Effect of Thermal Ageing and Dissolved Gas on Corrosion of 308L Stainless Steel Weld Metal in Simulated PWR Primary Water

Effect of Thermal Aging and Irradiation on the Electrochemical and Passivation Behavior of 308L Stainless Steel in Simulated Pressurized Water Reactor Environment

Corrosion of Phase and Phase Boundary in Proton-Irradiated 308L Stainless Steel Weld Metal in Simulated PWR Primary Water

Effect of Annealing on Microstructure of Thermally Aged 308L Stainless Steel Weld Metal

Unveiling the synergistic effect of thermal aging and irradiation corrosion on the passivation performance and stress corrosion cracking of 308 L stainless steel under high-temperature water environment

Effect of thermal aging on the environmental assisted cracking behavior of 308L weld metal in high temperature water

Effects of Long-Term Thermal Aging on the Stress Corrosion Cracking Behavior of Cast Austenitic Stainless Steels in Simulated Pwr Primary Water

Deformation and Cracking Behaviors of Proton-Irradiated 308L Stainless Steel Weld Metal Strained in Simulated PWR Primary Water

Interactive Effect of Thermal Aging and Proton Irradiation on Microstructural Evolution and Hardening of Δ-Ferrite in 308L Stainless Steel Weld Metal

Review of Thermal Aging of Nuclear Grade Stainless Steels

Effects of Dissolved Gas and Cold Work on the Electrochemical Behaviors of 304 Stainless Steel in Simulated PWR Primary Water

Effect of Thermal Pretreatment on the Corrosion of Stainless Steel in Flowing Supercritical Water

Environment assisted cracking of 308L weld metal in high temperature water

Short Time Oxidation Behavior of 308l Weld Metal and 316l Stainless Steel with Different Surface State in Simulated Primary Water with 0.1 Mg/L Dissolved Oxygen

Interactive Effect of Thermal Aging and Proton Irradiation on Microstructural Evolution and Hardening of 8-Ferrite in 308L Stainless Steel Weld Metal

Correlating oxidation resistance to stress corrosion cracking of 309L and 308L stainless steel claddings in simulated PWR primary water

Effect of Surface State on the Oxidation Behavior of Welded 308l in Simulated Nominal Primary Water of Pwr

Effect of Thermal Aging on the Microstructure and Mechanical Properties of ER308L/Z2CND18.12N2 Dissimilar Welds.

Effect of Aging Time on Electrochemical Corrosion Behavior of 2101 Duplex Stainless Steel

Effect of Post-Irradiation Annealing on Microstructure and Corrosion of Proton-Irradiated 308L Stainless Steel Weld Metal

Corrosion Behavior and Mechanism of Irradiated 304 Nuclear Grade Stainless Steel in High-Temperature Water