Abstract:Huge and critical structures, such as fuel storage tanks and nuclear power plants, are often built on dense sandy grounds, which may cause excessive plastic deformations under multidirectional cyclic shearing conditions caused by earthquakes. The lack of investigation of sand behavior under multidirectional loading may lead to unsafe designs, and thus significantly increase the maintenance cost for infrastructures during their long operational time, which might be longer than 100 years. This study presents a numerical investigation on the liquefaction behavior of dense sand under bidirectional cyclic simple shear using the discrete element method. The bidirectional cyclic simple shear tests with varying stress trajectories on the deviatoric stress plane, including figure-8, circular, and straight lines, were conducted. Additionally, a series of unidirectional loading tests was conducted in the simulation scheme for comparison purposes. The effect of the initial static shear on the cyclic behavior and liquefaction resistance of granular materials was examined. Four loading categories, including full reversal, partial reversal, intermediate reversal, and no reversal, were implemented in the numerical simulations. Although the presence of the initial static shear may enhance the cyclic resistance of granular samples under unidirectional loading, it mitigates the liquefaction resistance and promotes the failure of specimens under bidirectional shearing conditions. The microscopic analysis was performed to reveal the relationship between the fabric evolution and external loading, which can provide profound insights into the underlying mechanism of the cyclic behavior and liquefaction susceptibility of granular material when both the bidirectional shearing and initial static shear effects are considered.

Dynamic Properties of Toyoura Sand in Reliquefaction Tests

Effects of Strain History and Induced Anisotropy on Reliquefaction Resistance of Toyoura Sand

Previbration Signature on Dynamic Properties of Dry Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Energy-based Assessment of Cyclic Liquefaction Behavior of Clean and Silty Sand under Sustained Initial Stress Conditions

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

Experimental studies on dynamic and static properties of sand during repeated liquefaction events

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Understanding fabric evolution and multiple liquefaction resistance of sands in the presence of initial static shear stress

Factors Influencing Sand Re-liquefaction in Shaking Table Test

Re-liquefaction of Sand in Shaking Table

Liquefaction resistance of anisotropically consolidated sand under monotonic and cyclic undrained torsional shear

Investigating the influence of inherent soil fabrics on reliquefaction resistance of sands using DEM-clump simulation

Probing Fabric Evolution and Reliquefaction Resistance of Sands Using Discrete-Element Modeling

Experiment and Numerical Simulation of Repeated Liquefaction-Consolidation of Sand

Detection of Elastic Region Varied by Inherent Anisotropy of Reconstituted Toyoura Sand

Characterization of reconsolidation volumetric strain of liquefied sand and validation by centrifuge model tests

Verification of the Soil-Type Specific Correlation between Liquefaction Resistance and Shear-Wave Velocity of Sand by Dynamic Centrifuge Test