Abstract:Although Toyoura sand has been widely used as a standard material for physical model tests (particularly centrifuge model tests), its path-dependent stiffness degradation curves are rarely reported in the literature. This leads to difficulties in back-analyzing and understanding the physical tests involving significant changes in the direction of stress paths (such as unloading problems). In this study, path-dependent stiffness degradation curves of medium-dense Toyoura sand were determined by carrying out a series of stress-path triaxial tests, with local strain measurements. In the triaxial tests, four typical recent stress histories (changes of path direction = 0, 90, -90, and 180 degrees) were simulated. The measured small strain stiffnesses of Toyoura sand were then used to calibrate an advanced hypoplastic model that accounts for path-dependent soil stiffness at small strains. To justify the validity of the calibrated hypoplastic model and model parameters, a Type A numerical prediction and a centrifuge model test were carried out to simulate a typical unloading problem (i.e., excavation) in medium-dense Toyoura sand. Triaxial test results show that a 180 degrees reversal in the direction of the stress path increased the initial secant modulus of Toyoura sand by eight times. The path dependency of soil stiffness, however, vanished when the deviatoric strain exceeded 0.3%. The ground deformations (resulting from excavation) predicted by the numerical analysis show reasonable agreement with the measured data from the centrifuge test. This suggests the potential applicability of the calibrated soil model and its model parameters in predicting or back-analyzing other physical model tests in Toyoura sand.

Effects of Strain History and Induced Anisotropy on Reliquefaction Resistance of Toyoura Sand

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Energy-based Assessment of Cyclic Liquefaction Behavior of Clean and Silty Sand under Sustained Initial Stress Conditions

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Dynamic Properties of Toyoura Sand in Reliquefaction Tests

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

Cyclic Failure Characteristics of Silty Sands with the Presence of Initial Shear Stress

Probing Fabric Evolution and Reliquefaction Resistance of Sands Using Discrete-Element Modeling

Understanding fabric evolution and multiple liquefaction resistance of sands in the presence of initial static shear stress

Investigating the influence of inherent soil fabrics on reliquefaction resistance of sands using DEM-clump simulation

Experimental Study of Drained Anisotropy of Granular Soils Involving Rotation of Principal Stress Direction

Liquefaction of Sand under Monotonic and Cyclic Shear Conditions: Impact of Drained Preloading History

Influence of Liquefaction History on Liquefaction Susceptibility

Liquefaction resistance of anisotropically consolidated sand under monotonic and cyclic undrained torsional shear

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Detection of Elastic Region Varied by Inherent Anisotropy of Reconstituted Toyoura Sand

Comparison of Cyclic Liquefaction Behavior of Clean and Silty Sands Considering Static Shear Effect

Experimental and numerical modeling on liquefaction resistance of geotextile reinforced sand

Effects Of Pore Water Redistribution On Post-Liquefaction Deformation Of Sands

Undrained Anisotropy and Cyclic Resistance of Saturated Silt Subjected to Various Patterns of Principal Stress Rotation