Abstract:The corrosion behavior of Alloy 600 (UNS N06600) is investigated in hydrogenated water at 260°C. The corrosion kinetics are observed to be parabolic, the parabolic rate constant being determined by chemical descaling to be 0.055mgdm−2h−1/2. A combination of scanning and transmission electron microscopy, supplemented by energy dispersive X-ray spectroscopy and grazing incidence X-ray diffraction, are used to identify the oxide phases present (i.e., spinel) and to characterize their morphology and thickness. Two oxide layers are identified: an outer, ferrite-rich layer and an inner, chromite-rich layer. X-ray photoelectron spectroscopy with argon ion milling and target factor analysis is applied to determine spinel stoichiometry; the inner layer is (Ni0.7Fe0.3)(Fe0.3Cr0.7)2O4, while the outer layer is (Ni0.9Fe0.1)(Fe0.85Cr0.15)2O4. The distribution of trivalent iron and chromium cations in the inner and outer oxide layers is essentially the same as that found previously in stainless steel corrosion oxides, thus confirming their invariant nature as solvi in the immiscible spinel binary Fe3O4–FeCr2O4 (or NiFe2O4–NiCr2O4). Although oxidation occurred non-selectively, excess quantities of nickel(II) oxide were not found. Instead, the excess nickel was accounted for as recrystallized nickel metal in the inner layer, as additional nickel ferrite in the outer layer, formed by pickup of iron ions from the aqueous phase, and by selective release to the aqueous phase.

Corrosion Behavior of FeCrAl Alloy and NiCr Coated Zircaloy-4 in Hydrogenated Water

Incipient Corrosion of FeCrAl Alloys in H3BO3- and LiOH-containing Pure Water at 360 °C and 18.5 MPa

Corrosion Behavior and Mechanisms of Al2O3 and Mo Coated Zircaloy-4 in High-Temperature Lithiated Water

Uniform Corrosion Behavior of FeCrAl Alloys in Borated and Lithiated High Temperature Water

Microstructural Evolution of the Cr/FeCrAl Coated Zircaloy-4 under Simulated PWR and High-Temperature Steam Oxidation Environments

Corrosion of Zircaloy-4, Zr-1Nb and FeCrAl Alloys in Deaerated Water at 330 °C and 14 MPa: Superior Corrosion Resistance and Corrosion Mechanism of FeCrAl Alloy by Experiments and Molecular Dynamics Simulations

Microstructure of FeCrAl Thin Film Composed of Nanocrystals Deposited on Zr Alloy and Their Corrosion Behavior under Water Steam Atmosphere.

Insights into the Superior Stress Corrosion Cracking Resistance of FeCrAl Alloy in High Temperature Hydrogenated Water: the Critical Role of Grain Boundary Oxidation

Insights into Oxidation and Nitridation of Alumina-Forming FeCrAl Alloy after Supercritical Water Exposure: Effect of Pre-Corrosion on High-Temperature Damage Behavior

Improving the Corrosion Resistance of FeCrAl Alloy in High Temperature Hydrogenated Water Through Gaseous Pre-Oxidation

Corrosion Degradation Mechanism of Cr-Coated Zr-4 Alloy under Simulated Nuclear Conditions for Accident-Tolerant Fuel

Corrosion and Wear Properties of Cr Coating and ZrO2/Cr Bilayer Coating on Zr-4 Alloy

Hydrothermal corrosion of Cr C and Ti-Al-C carbide ceramic coatings on Zircaloy: Corrosion behavior, mechanism and influence of water exposure on pressurized steam oxidation resistance

Corrosion behavior of Cr-coated zirconium alloy cladding in LiOH/H3BO3-containing water at 360 °C

Investigation on the Oxidation and Corrosion Behaviors of FeCrZr Alloy As a Protective Material for Zr Cladding

Corrosion of FeCrAl Alloys Used As Fuel Cladding in Nuclear Reactors

Effect of Elements on Hydrogen Pickup and Corrosion Behavior of ZrFeCr Alloys in 500°C Steam

High-temperature corrosion of Fe-Ni-based alloy HR6W, Ni-based alloys Haynes 282 and Inconel 740 in supercritical water at 450 °C and 25 MPa

On Corrosion of Zirconium Alloy in Dissolved Oxygen Water：The Role of Cu Addition

Corrosion behavior of NiCrFe Alloy 600 in high temperature, hydrogenated water

Intergranular corrosion of Ni-30Cr in high-temperature hydrogenated water after removing surface passivating film