Abstract:This work describes a viable hydrogen-induced sensitisation process toward stress corrosion cracking in chromia-forming nickel base alloys owing to oxidation by water. A mechanistic chemical understanding of the stress corrosion based on repeated cracking and re-healing of the oxide scale emerges from experiment-guided first-principles calculations. Piggybacking processes during repeated oxide scale cracking-healing cycles are understood to cause sensitisation towards the formation and growth of macroscopic cracks. Under light-water reactor conditions, the healed oxide scale comprises an outer region composed of chromium depleted nickel ferrite, and non-protective chromia, nickel oxide, nickel hydroxide. An inner nickel iron chromite layer provides the passivating barrier that controls the oxidation rate at a steady state. Early during the re-healing of a crack in the oxide scale, water is conveyed to the alloy/scale interface by hydration/dehydration of composite nickel oxy-hydroxide Ni(OH) 2 ∙NiO inclusions in the scale. At later stages, Ni(OH) 2 ∙NiO serves as oxidant of preferentially chromium, while hydrogen is released as H 2 (g) into the primary water or becomes picked up by the alloy, possibly while assisting in the reduction of NiO to form nickel metal particles. Oxidation by water equivalents at the confining alloy/scale interface favours hydrogen pick-up in the alloy that becomes increasingly detrimental owing to enrichment and inward diffusion of hydrogen along alloy grain boundaries where pinning of alloy vacancies causes mitigation of outward diffusion of chromium, which in turn hampers crack re-healing while promoting alloy embrittlement.

Intergranular corrosion of Ni-30Cr in high-temperature hydrogenated water after removing surface passivating film

Corrosion of FeCrAl-1Nb alloy in Deaerated Water at 290 °C and 7MPa: The Oxidation Behavior of Grain Boundary

Effects of the Cr-Depletion on the Stress State of the Sublayer of Ni-Base Alloys Oxidized in High Temperature Water

Corrosion Behavior of Ultrafine-Grained CoCrFeMnNi High-Entropy Alloys Fabricated by High-Pressure Torsion

Dependence of intergranular precipitation on grain boundary characteristics in Ni–Cr–Fe–Mo–Cu alloy

Modeling Selective Intergranular Oxidation of Binary Alloys

Corrosion of FeCrAl-1Nb Alloy in Deaerated Water at 290 ℃ and 7mpa: the Oxidation Behavior of Grain Boundary

High-throughput first-principles study on the effect of Ni segregation on the formation of Cr-depleted zone and corrosion resistance of S32205 duplex stainless steels

Chromium Depletion in a Ni-30Cr Alloy During High-Temperature Oxidation

Corrosion Resistance, Composition, and Stratification of Passive Films: Ni-22Cr and Ni-22Cr-6Mo Alloys Passivated and Exposure Aged in Acidic Chloride Solutions

Influence of grain refinement via high-pressure torsion on corrosion behavior of medium- and high-entropy alloys CoCrFeNi and CoCrFeMnNi with various chromium contents

First-Principles Investigation of Grain Boundary Effects on Fluorine-Induced Initial Corrosion of NiCr Alloys

The time dependence of proton irradiation effect on the intergranular oxidation of 316L stainless steel in high-temperature hydrogenated water

Corrosion behavior of NiCrFe Alloy 600 in high temperature, hydrogenated water

Hydroxyl transport mechanisms upon passivation of Cr-Fe-Co-Ni-Mo multi-principal element alloy surfaces investigated by isotopic labelling

XPS study of the thermal stability of passivated NiCrFeCoMo multi‐principal element alloy surfaces

Microstructural understanding of the oxidation and inter-diffusion behavior of Cr-coated Alloy 800H in supercritical water

The Intergranular Corrosion Susceptibility of Metastable Austenitic Cr–Mn–Ni–N–Cu High-Strength Stainless Steel under Various Heat Treatments

Passivation of Ni-Cr and Ni-Cr-Mo Alloys in Low and High pH Sulfate Solutions

Stress-Corrosion Cracking Sensitization by Hydrogen upon Oxidation of Nickel-base Alloys by Water – an Experiment-Guided First-Principles Study

Effect of μ precipitation and γ′ evolution on intra/intergranular strength of Ni-Co-Cr-based superalloys after 800 °C thermal exposure