Preparation of Barbecue Charcoal Using Residue Produced after Biomass Gasification and Pollutant Emission Test During Combustion

Zhenkun Guo,Fanhui Guo,Yang Guo,Zekai Miao,Yonghui Feng,Jianjun Wu,Yixin Zhang

DOI: https://doi.org/10.1016/j.jece.2021.107074

IF: 7.7

2022-01-01

Journal of Environmental Chemical Engineering

Abstract:The residue derived from biomass gasification is abundant and harmful to the environment. Hence, to solve this problem is very imminent. It is a good way to make biomass gasification residue into barbecue charcoal (BC), which has practical significance. In the paper, BC was fabricated using briquetting drying process (BDP) and secondary carbonization process (SCP), respectively. The effects of the BDP and SCP were both investigated. The optimum conditions for BDP were to use composite binder, whose compositions were 10% of starch solution and 10% of polyvinyl alcohol solution. Similarly, the optimal conditions in the SCP were obtained as follows: 17% of tar ratio, 500 degrees C of carbonization temperature and 4 h of carbonization time. Under these conditions, the compressive strength of BC was greater than 500 N/piece, which could meet the strength standards for the production of barbecue application. Simultaneously, the physical and chemical properties of BC were studied. The results showed that the combustion time of the two kinds of BC was more than 90 min. The pollutant emissions of BC were reduced, such as SO2 and NOx. It was proved that the residue after biomass gasification could be used to produce BC and it's friendly to the environment.